Laserfiche WebLink
Step 2 Instailinci the Black .Spill Cantainer onto the M/F 4X4 Riser Adaptor <br /> A. By hand , thread the black spill container onto the male threads of the M/F 4X4 riser adapter <br /> taking care not to cross thread the spill container riser. These threads are straight threads not <br /> NPT pipe threads . The spill container must screw down and seat on the top of the drop tube <br /> flare ( Fill ) or on the top of the M/F 4X4 riser adaptor sealing surface (Vapor) . <br /> Step 3 — Tiahteninq the Spill Container <br /> Using a 1/z" drive torque wrench and the Black tool adapter (T-7101 or T-7002 , Black) from <br /> PhII-rite T-7043 Tool Kit, tighten the Spill Container onto the M/F 4X4 Riser Adaptor threads to <br /> a torque value between 75 and 100 ft. Ibs . <br /> Step 4 — Final , Installation <br /> Check the measurement from the top of the black spill container to the top of the stainless <br /> steel sleeve at finish grade . Ensure there is at least 11 /4" inches of clearance (more is OK) <br /> from the top of the black spill container to the top of the stainless steel sleeve at finish grade . <br /> This will allow for the water tight cast Iron lid to fit properly and ensure that the spill container <br /> and tank riser are not in direct contact with the cast iron lid . This ensures the concrete with <br /> manway cover are not load bearing onto the tank fill and vapor risers . <br /> Step 5 — Drain Valve Testing <br /> Test the drain valve assembly as described in CARR procedure TP-201 . 1 D . <br /> Step 6 — After Spill. . Container . Installation <br /> The spill container is now ready for the installation of the rotatable (swivel ) adaptor and dust <br /> cap . Install the fill and/or vapor swivel adaptor using the SWF- 100B/SWV- 101 B Installation <br /> Instructions . <br /> 4of8 <br />