COMPLIANCE INFO_2019 - Laserfiche WebLink

Home Browse Search

Recommended Practices for the Testing and Verification of Spill,Overfill,Leak Detection and Secondary Containment Equipment at UST Facilities of the sump, add water to within I inch of the 6.6 Accelerated Precision Hydrostatic Test for Spill top of the sump. Buckets and Containment Sumps. Electronic preci- 2.Place the measuring stick vertically at the lowest sion test equipment can be utilized to test spill buckets point in the sump and extending above the water and containment sumps. It incorporates more sensitive level in the sump to allow for an accurate mea- equipment that permits a test to be conducted in a shorter surement to be taken. The location of the mea- Period of time.The procedures use the same test fluid and suring stick must remain the same for each water tests the same volume as other methods outlined in this level measurement. Document the initial water chapter.The manufacturer of the measurement equipment level measurement as measured from the bottom should specify the precision and duration of the test and of the sump.Alternative measurement methods the pass/fail criteria. However, pass/fail criteria should may be used provided that the measurement to not be less stringent than those prescribed for the 1-hour 1/16 (0.063)inch can be made. test in Section 6,5.7. 3.Thke all precautions to prevent the water level The data sheet for Sections 6.2 or 6.5 may be used for this from being disturbed during the duration of the test Refer to Appendix D. test. 6.7 Proper Handling of Test Liquids. Test liquids 4.After 1 hour, document the ending water level must be handled properly.Check with the AHJ regarding measurement. requirements. 5.Upon completion of the test: - --- - • remove all water and properly dispose of it according to Section 6.7; • reinstall any interstitial monitoring sensors in their proper positions; • return the test boots or secondary containment fittings to their pre-test operating configurations; • inspect and reinstall all containment sump lids, r gaskets and covers. r e-^ Water FIGURE 6-7. The test fluid leve/in the tank sump must be at least 4 inches above the highest sump penetra- Etectr;cat tion or sidewall seam. - Conduit — In----- I` , D F , Product P�pingN. n F I: 0 3M9 FIGURE 6-6. To prevent leakage, check all penetration , " ENVIRONMENTAL HEALTH fittings before adding water to ensure they make a tight seat. •i I)FPA RTAA F NIT FIGURE 6,6. Mea- suring sticks used 6.5.7 Pass/Fail Criteria. If the water level to measure the changes less than 1/8(0.125)inch,the containment water level should sump passes the integrity test. be securely mount- If the water level changes 1/8(0.125)inch or great- ed to ensure that er, the containment sump fails the integrity test. g' they do not move during the test. pei.org