COMPLIANCE INFO_2019 - Laserfiche WebLink

Home Browse Search

UNDERGROUND STORAGE TANK MONITORING SYSTEM CERTIFICATION FORM VI11 . MONITORING SYSTEM AND PROGRAMMING This section must be completed if a monitoring panel is used to perform leak detection monitoring. Y N NA Are the visual and audible alarms operational ? n ❑ ❑ Were all sensors visually inspected for kinks and breaks in the cables and for residual buildup to ensure that floats move freely, E ❑ ❑ functionally tested , and confirmed operational? Were all sensors installed at lowest point of secondary containment and positioned so that other equipment will not interfere with their R ❑ ❑ proper operation? Was monitoring system set-up reviewed to ensure proper settings? M ❑ ❑ Was the monitoring panel's backup battery visually inspected , functionally tested , and confirmed operational? ❑ ❑ Does the flow of fuel stop at the dispenser if a leak is detected in the under-dispenser containment? EI ❑ ❑ Does the turbine automatically shut down if the piping secondary containment monitoring system fails to operate or is electrically E ❑ ❑ disconnected? Does the turbine automatically shut down if the piping secondary containment monitoring system detects a leak? [E ❑ ❑ Which sensors initiate positive shut down? (Check all that apply.) Q Sump ❑ Under-dispenser containment If alarms are relayed to a remote monitoring station , is all communications equipment (e .g , modem) operational ? El ❑ ❑ For any answer of "N" above, describe in section IX how and when these deficiencies were or will be corrected. IX. COMMENTS X. IN -TANK GAUGING TESTING 1 Check this box if tank gauging is used only for inventory control . (Do not complete this section.) ❑ Check this box if NO tank gauging equipment is installed . (Do not complete this section.) Y N NA This section must be completed if in-tank gauging is used to perform leak detection monitoring. Has all input wiring been inspected for kinks and breaks in the cables and for proper entry and termination , including testing for ground ❑ ❑ faults ? Were all in-tank gauging probes visually inspected for damage and residue buildup to ensure that floats move freely , functionally tested , El ❑ ❑ and confirmed operational ? Was accuracy of system's product level readings tested ? ❑ ❑ Was accuracy of system's water level readings tested ? (] ❑ ❑ Were all probes reinstalled properly? an ❑ ❑ Were all items on the equipment manufacturer's maintenance checklist completed ? Eil ❑ ❑ Foran answer of "N" above, describe in section X1 how and when these deficiencies were or will be corrected. XI . COMMENTS Probes were still tested . i l r i S l,` Y = Yes, N = NO, NA = Not Applicable