COMPLIANCE INFO_2019 - Laserfiche WebLink

Home Browse Search

Equipment EBW Phase I Required Inspection & Maintenance Spill Containment Manholes Drop Tube Mounted Overfill Prevention • Perform inspection and maintenance duties at least Valves once a year. Perform inspection and maintenance duties at least • Remove any standing liquid and dispose of it properly. once a year. • Brush all buildup off of the brass drain valve screen ( if Inspect the inside of drop tubes for broken dip sticks or applicable) . noticeable damage to the valve flapper. If any damage is • Remove all dirt and foreign materials , observed , then the valve must be replaced . • Scrape all foreign materials away from the tank lid If it has not already performed during drain valve testing , sealing surfaces . leak test the Drop Tube assembly using the established • Should it be necessary to replace a drain valve due to "Pressure Integrity Test" for Drop Tube/ Overfill breakage or considerable contamination buildup , use Prevention Device (TP20141 C or TP201 . 1 D) . EBW 705-337A 9 Replacement Drain Valves only. EBW doesn 't require that the drop tube be pulled for • Perform a leak test using the established " Pressure inspection unless damage is noted . Should local authority Integrity Test" for a combination of Drop Tube, Drain require removal of the drop tube , the following seals and Valve , and Overfill Prevention Device (TP201 . 1 D ) . inspection steps are necessary: • Use 90079 Drop Tube Isolation Test Kit . • Replace Drop Tube Isolation Gland ( if applicable) seal Rotatable Fill & Vapor Adapters , Dust Caps & kit-90090 Probe Riser Adapters • Replace Drop Tube Flange Gasket — 11182-01 • Perform inspection and maintenance duties at least • Inspect the Tank Bottom Protector for freedom of once a year. movement . Repair or replace if necessary. • Inspect all product and vapor riser dust cap seals for • Inspect OPD components , use instructions on EBW damage. If damage is observed , replace the seal with from 6329 . either the Aluminum Vapor Cap Seal or the Nylon • Inspect drop tube joint sealant. Repair with EBW part # Product Cap Seal . 11372-01 only. • Perform Rotatable Adapter maintenance as specified by Ball Floats & Extractor Valve Bodies PhilJite Enterprises , Inc. Perform established " Static • No annual maintenance is required . Torque Test" , TP201 . 1 B . • Pressure Vacuum Vent Valves Leak testing should be accomplished during the " Pressure Integrity Test" for a drain valve or Drop Perform the required maintenance as specified by Tube Mounted Overfill Valve , TP201 . 1 C or TP201 . 1 D . Husky Corporation . Annual maintenance of the probe riser cap assemblies At least once every three years , unless otherwise specified is normally not required . Whenever probe service is by a local authority, perform the established " Static necessary, inspect the service cap seal for damage and Pressure Performance Test" (TP201 . 3) . replace it , if necessary, at that time with a Probe Riser Cap Seal. Please contact Technical Support if assistance is needed . Franklin Fueling Systems 3760 Marsh Road Madison, WI 53718, U.S.A. Tel: + 1608 838 8786 Tel : USA & Canada 1 800 225 9787 Tel : Mexico 001 800 738 7610 O 2015 17-6308 rev 3 www.franklinfueling.corn