COMPLIANCE INFO_2019 - Laserfiche WebLink

Home Browse Search

POMECO Multi -Port Spill Container Manhole Installation Instructions 3 . Remove the cover and measure the distance from the top of the tanks to the final grade . 1 . Mark off finish grade . (See Figure 1 . ) 4 . Cut the riser(s) from the underground tank so Finish Grade that both the fill and vapor risers are set below the final grade . Use the dimensions below : Spill Container Inches below grade ( L) 5 Gal , Cast Iron Base 15 '/" Figure 1 5 Gal . Composite Base 17 % 7 . 5 Gal . Cast Iron Base 191/2 7 . 5 Gal . Composite Base 21 1/2 2 . Set multi -port manhole assembly (skirt , ring , and Note: Add an extra 3414 " when using an OPW cover) to the final grade position . (See Figure FSA400 Face Seal Adaptor. (See Figure 2.) 2 . ) 5 . Deburr and thoroughly clean riser pipe(s) . Finish Grade & Apply pipe dope to riser(s) . The pipe dope is to be a non -hardening , gasoline resistant , pipe thread seal compound . 7 . Install OPW FSA-400 Face Seal Adapter onto riser. ( Recommend Torque , 4" NPT, 125 ft-lbs min . to 250 ft-lbs max. ) . Apply pipe dope to FSA-400 . The pipe dope is to be a non. hardening , gasoline resistant , pipe thread seal compound . This is optional for spill containers that are on the vapor lines . 8 . Thread the spill containers on hand tight . Note : Do NOT attempt to completely tighten the Figure 2 containment bucket by using the containment bucket mounting ring at the top of the bucket . Note : It is strongly recommended that POMECO 9 . Inspect the containment bucket gasket(s) and covers be installed with the following minimum the ring gasket for damage . Replace the clearances . Sheet metal skirts should have gasket(s) if they are damaged . adequate clearance between the tank sump riser 10 . Apply an even bead of PISCES SL- 1100 to the sidewall and or the sump top hat. A minimum of topside of the containment bucket gasket(s) , one and a half inches clearance on all sides is (See Figure 4 . ) recommended between the POMECO skirt and the tank sump wall or the sump top hat wall . A , ISCES SL- 1100 minimum of two inches clearance is ' — recommended between the bottom of the j ing POMECO skirt and the horizontal surface of the � � i Gasket tank sump or sump top hat. These clearances are recommended to allow adequate water migration away from the sumps . Great care should be used to maintain the recommended ----- ontainment clearances when setting the rings and pouring Bucket the concrete . (See Figure 3 . ) Gasket Figure 4 a 1 % Min N 11 . Apply an even bead of PISCES SL- 1100 to the topside of the ring gasket . (See Figure 4 . ) 12 . Replace the multi -port cover, centering the riser(s ) as close as possible in the containment openings . Be very careful not to move or damage the gaskets . Figure 3 POMECO Multi port Spill Container Page 2