COMPLIANCE INFO_2019 - Laserfiche WebLink

Home Browse Search

UNDERGROUND STORAGE TANK MONITORING SYSTEM CERTIFICATION FORM (Page 4 of 6) VIII . MONITORING SYSTEM AND PROGRAMMING This section must be completed if a monitoring panel is used to perform leak detection monitoring. Y N NA Are the visual and audible alarms operational ? 0 ❑ ❑ Were all sensors visually inspected for kinks and breaks in the cables and for residual buildup to ensure that floats move freely, N El ❑ functionally tested , and confirmed operational? Were all sensors installed at lowest point of secondary containment and positioned so that other equipment will not interfere with their proper operation? Was monitoring system set-up reviewed to ensure proper settings? ❑X ❑ El Was the monitoring panel's backup battery visually inspected , functionally tested , and confirmed operational? FX] 901 ❑ Does the flow of fuel stop at the dispenser if a leak is detected in the under-dispenser containment? QX ❑ ❑ Does the turbine automatically shut down if the piping secondary containment monitoring system fails to operate or is electrically 0 ❑ ❑ disconnected ? Does the turbine automatically shut down if the piping secondary containment monitoring system detects a leak? ❑ ❑ Which sensors initiate positive shut down? (Check all that apply.) 0 Sump 0 Under-Dispenser Containment If alarms are relayed to a remote monitoring station , is all communications equipment (e.g . , modem) operational? ❑ ❑X For any answer of "N" above, describe in Section 1X how and when these deficiencies were or will be corrected. IX. COMMENTS i I i z X. IN -TANK GAUGING TESTING ❑ Check this box if tank gauging is used only for inventory control. (Do not complete this section.) F1Check this box if NO tank gauging equipment is installed . (Do not complete this section.) Y N NA This section must be completed if in-tank gauging is used to perform leak detection monitoring. Has all input wiring been inspected for kinks and breaks in the cables and for proper entry and termination , including testing for ❑ ❑ round faults? Were all in-tank gauging probes visually inspected for damage and residue buildup to ensure that floats move freely, functionally ❑ ❑ tested , and confirmed operational? Was accuracy of system's product level readings tested ? Q ❑ ❑ Was accuracy of system's water level readings tested? Q ❑ ❑ Were all probes reinstalled properly? FX I ❑ ❑ Were all items on the equipment manufacturer's maintenance checklist completed? Q I ❑ ❑ For any answer of "N" above, describe in Section Xl how and when these deficiencies were or will be corrected. XI . COMMENTS Y = Yes, N = No, NA = Not Applicable