Laserfiche WebLink
Adjusting the Overfill Alarm Horn Volume <br /> O p <br /> 1. The adjustment screw is on the front of the horn body. <br /> 2. Locate the screw where shown. <br /> 3. Using a 1/16" hex key, turn the screw counterclockwise C� <br /> to make the horn louder. Turn the screw clockwise to <br /> make the horn quieter. <br /> i1 <br /> O <br /> J <br /> Q � <br /> Adjusting the Overfill Alarm Timer Cycle <br /> 1. Loosen the 4 screws which hold the Overfill Alarm door <br /> closed. <br /> 2. Slide the brackets out of the way and open the door. LOAD LINPUT ` <br /> 3. Locate the timer module located inside the Overfill <br /> Alarm. <br /> 4. You can adjust the time will remain on between 0—60 30 <br /> seconds. Adjust the time by turning the knob to the 1 40 <br /> desired setting. Clockwise to increase the time, • ' <br /> counterclockwise to decrease the time. <br /> UJ <br /> S. When finished, close the door and retighten the <br /> brackets and cover screws. <br /> Testing the Overfill Alarm with the Arknoxvledgment Switch <br /> 1. If you have chosen to install the optional _ <br /> Acknowledgement Switch, ensure the power is on to C_ <br /> the Overfill Alarm and the Acknowledgement Switch <br /> 2. Press and hold the TEST button located on the side of ACKNOWLEDGED n*, <br /> the Acknowledgement Switch. Test <br /> 3. The Overfill Alarm will sound and the red beacon will Button <br /> start flashing. <br /> 4. If you continue to hold the TEST button, the horn will <br /> turn off at the pre-determined time set above. RESET Cl <br /> S. The red beacon will continue to flash until the TEST <br /> button is released. <br /> n <br /> 8 <br />