COMPLIANCE INFO_2020 - Laserfiche WebLink

Home Browse Search

Operation 1. Insert aerosol can, NOZZLE END DOWN, into housing sleeve, so that the shoulder of the can rests on the internal gasket. Be sure to remove cap and bulky nozzles from aerosol can prior to insertion 2. Lower sliding top plate over the bottom of the inverted can and firmly engage against plastic sleeve. Tighten the lock knob on the side of the housing. Tighten sealing knob to further depress aerosol can to internal gasket. 3. Push handle down firmly until completely depressed and hold in place while can released initial pressure. Slowly raise the handle and immediately depress, this will control the rate of pressure and content evacuation from the aerosol can. In order to prevent backpressure, allow the contents of the can to drain into the collection drum (about 20 seconds) 4. When the aerosol can's contents have been completely discharged (about 20 seconds or when can contents are obviously discharged), turn sealing knob counter-clockwise 3 rotations, unfasten the lock knob and lift the can to the brim of the unit housing. Some residual fluid may be entrapped between the lip of the can and the hole created by the puncturing device. Tip the can to allow the residual to discharge into the unit. A rag may be used to remove any remaining residual from around the can. Remove the can from the housing, lower sliding top plate to rest on plastic sleeve to seal the collection drum, and manage the empty can appropriately. 5. Continuously monitor the colormetric indicator to determine when the carbon in the carbon canister is approaching saturation. If the indicator indicates that the carbon is saturated, discontinue puncturing and replace the carbon canister. 6. When the unit operations are complete, the unit should be locked out to avoid unauthorized use. If the collection drum is more that 70%full, secure the drum and do not return it to use. The unit may also be secured in place by inserting a padlock to prevent unauthorized use. The padlock is inserted in the through-hole located on the slide bar.