INSTALL_2020 - Laserfiche WebLink

Home Browse Search

5 , Place the remaining ring over the sump entry fitting in the 10. Do not disturb assembly until the adhesive is cured , This inside of the sump and rotate to the desired angle . Make includes bonding of pipe to the sump entry fitting and alignment mark on both the sump wall and the ring when installing the threaded outlet fitting , See adhesive kit at the desired angle to make the "free " surface of the ring instructions for cure times , as close to perpendicular (square) to the axis of the fitting as possible . 11 . The use of an industrial hot air gun may speed up the curing process , Do not overheat . 6 , Mix one 8 oz. PSX-34 or one 8069 adhesive for each fitting per the instructions in the adhesive kit , Filler should 12 . Remove 114 inch plastic threaded outlet protector, be used with 8069 to insure proper sealing of alignment Apply adhesive only to the 1/4 inch fitting and screw rings . into the 114 inch threaded outlet . Tighten to 40 inAbs , or 11h-2 turns past hand tight , 7 . Apply adhesive generously, approximately ' /1s inch thick , to the inside and the outside of the sump walls where the NOTE: Over-tightening the tapered threads of the fitting alignment rings are located , Coat the edges of the hole may damage the fitting body. DO NOT OVERJIGHTEN. cut in the sump wall . Apply a thin coating of adhesive to the bonding surfaces of the alignment rings . After installing the fitting , be sure the interstitial space is free from excess adhesive . Install a short hose and blow 8 Line up rings with alignment marks and press together excess adhesive through the air passage , firmly holding the fitting in place from the outside of the sump . NOTE: Verify with testing company or monitoring manufacturer if a larger thread is needed for their 9 . Slide the metal retaining ring over the inside section of equipment. After the port fitting is installed, do not the sump entry fitting and against the inner alignment remove , ring until all the rings are tight against both sides of the sump wall . (A short section of 4 inch pipe may be used 134 Connect only flexible tubing or hoses to the port fitting . to drive the metal retaining ring over the fitting) , Be sure there is an adhesive bead visible between the rings and NOTE: Tubing or hoses must be rated to full vacuum . the sump wall , The metal ring must hold the assembly in position while the adhesive cures . If the assembly is not Drawings below show the assembly of the fitting and tight against the sump wall , firmly press the sump entry associated pipe when using either size-over-size fitting against the outside sump wall while pressing the containment systems or coaxial pipe . metal ring against the alignment ring on the inside , Clean excess adhesive from all bonding surfaces . ADHESIVE BEAD 40 RETAINING RETAINING RING RING 2