Laserfiche WebLink
ADVANTEOO&M MANUAL <br /> 4 If the control panel has an elapsed time meter : <br /> (ETM) and/or a cycle counter (CT), read and <br /> record these values on the Field Maintenance <br /> Report Form. l . <br /> ETM's and CT's are valuable troubleshooting <br /> tools if problems occur with the system. ETM <br /> and CT data signal high water usage,low water <br /> usage or tank leakage,and excessive pumping, <br /> among other operating situations. <br /> ted' <br /> + 4 Verify float operation.With MOA switch in <br /> - <br /> Automatic,simulate system operation by lifting <br /> V `v the floats in the same order that the liquid would <br /> lift them (bottom first,top last). <br /> ,. 5 Determine whether the Biorube"effluent <br /> k filter needs cleaning by testing the change in the <br /> k v: tank's liquid level when the pump is on.Turn the <br /> recirc pump on by flipping the MOA switch in <br /> f. the control panel to Manual.Watch the liquid <br /> LL:; <br /> level inside the screened vault as the pump <br /> is running for about 30 seconds to deter- <br /> mine if there is any noticeable liquid level <br /> 5 Confirm operation of audible and visual differential between it and the tank liquid <br /> alarms per the installation,operation,and setting level. Return the MOA switch to Auto.When <br /> instructions for the control panel that comes with the liquid level difference between the inside and <br /> the system. outside of the vault is about two inches or more, <br /> Pumping System or if the low-level alarm is activated, the Biotube® <br /> cartridge may need to be cleaned. <br /> Pump systems should be inspected annually to <br /> ensure that they are operating properly. Unscrew <br /> the stainless steel bolts that fasten the fiberglass rv" " <br /> lid over the pumping equipment. Remove the ,m <br /> fiberglass lid for an inspection that includes these <br /> steps: <br /> Vdt/ m <br /> 1 Verify that there are no obvious holes or leaks `" <br /> in the riser or around the perimeter of the riser ' <br /> connection to the tank.Wetness or water marks <br /> may be an indication of weeping. <br /> I <br /> 2 Inspect splice box to ensure lid and connec- <br /> tions are secure. <br /> F 3 Verify that floats are in good condition and <br /> properly secured to the float tree.Verify that float <br /> cords are neatly wrapped inside the riser so that <br /> they cannot interfere with the operation of the <br /> floats. <br />