COMPLIANCE INFO_2021 - Laserfiche WebLink

Home Browse Search

VR-202-Z -49 Exhibit 2 Data Transfer Unit The optional Data Transfer Unit can be installed as a replacement for underground wire and conduit for both the Vapor Flow Meter and Vapor Pressure Sensor. The TS-DTU must be wired per the INCON Data Transfer Unit Dispenser Retrofit Manual 000-2146 of the CARB Approved Installation, Operation and Maintenance Manual. A minimum of two units are required when installing DTUs, one in the GDF and one in a dispenser. A single site can mix and match between dedicated cables and DTU installation methods. See Figure 2-21. Shutdown Control The Console must be wired per the INCON VRM Install, Operators, and Maintenance Manual 000-2058 of the CARB Approved Installation, Operation and Maintenance Manual such that it shall automatically prohibit the dispensing of fuel through shutdown of individual dispensers during a CP-201 ISD failure alarm. Console Modules The VRM Operability Test Procedure in Exhibit 10 and in the INCON VRM Install, Operators, and Maintenance Manual 000-2058 of the CARB Approved Installation, Operation, and Maintenance Manual shall be used to verify the proper selection and setup of the Console Modules. Training Program All fuel management system contractors must successfully complete the applicable Franklin Fueling Systems training program before they can install, startup, and service automatic tank gauge console equipment. Contractors must have up-to-date FMS Installation - INCON° Level 1 & FMS Programming - INCON°Level 2 certifications to install and startup consoles manufactured by Franklin Fueling Systems. Contractors must have an up-to-date VRM Installation INCON°Level 5 certification to install, startup and service the VRM system. The schedule, fee and registration information for the Authorized Service Contractor (ASC) training program can be found at https:HuniversitV.ffspro.com/en/. Current console and VRM training certification information for contractors whose profiles are publicly visible can be obtained via the Franklin Fueling Systems certified installers search page at https://university.ffspro.com/en/search/. Current certification information can also be obtained by contacting Franklin Fueling Systems at +1 .608.838.8786. Maintenance The console, including interface modules, do not require scheduled maintenance. The VRM System uses a Self-Test Monitoring feature that is designed to verify proper se- lection, setup and operation of the console and sensors. There is no recommended maintenance, inspection nor calibration for the Vapor Flow Meter or the Vapor Pressure Sensor. Servicing should be performed in response to warning or alarm conditions.