Laserfiche WebLink
Healy 1301 Flow Limiter <br /> U'xf 13e7+s I-]1 Cp <br /> HEALY SYISTEMS <br /> FLOW LIMITER �} , <br /> k10DEL 4301 S` <br /> r <br /> Oil1 3 1..� , „ _ �r_ . ,I 1.t FLOW <br /> STRAIGHT THR1AD5 <br /> - ON BOTH ENDS <br /> +UDSON, N H, US-4 <br /> Quad Rings O-ring <br /> P/N H B4 P/N H B2 <br /> The Healy Model 1301 Flow Limiter is designed for installation into the lower half of the Healy P/N <br /> 8701 VV breakaway before installation of a Healy Systems primary hose. The flow limiter reduces the <br /> product dispenser rate to conform to the U.S. EPA 10.0 gpm maximum dispensing limit. <br /> Installation Instructions: Lubricate the quad rings and O-ring before assembly with oil or grease. <br /> Do not use pipe sealant or tape on threads or seals. Install the male end of the flow limiter into the <br /> breakaway as shown below and tighten to 35 to 70 foot pounds. Install the primary hose and nozzle <br /> according to their instructions. Make sure all fittings are tight, test for any leaks and check to be sure <br /> the flow does not exceed 10.0 gpm with the nozzle fully open (lever held all the way up). <br /> Field replaceable parts are limited to replacement of the Quad Rings or O-ring. There is no <br /> maintenance required of the internal parts. <br /> L � R f <br /> Olt <br /> mvr-�Iy Iiii . -:,- <br /> Dispenser Whip 8701 VV Flow Primary Nozzle <br /> Hose Breakaway Limiter Hose <br /> 7-1 <br /> GARB Approved IOM 7-Healy Flow Limiter Model 1301-Executive Orders VR-201 and VR-202 <br />