Laserfiche WebLink
Healy 1302 Flow Limiter <br /> HF-4LY SYSTEMS <br /> I . IIS FLOW LIMITER <br /> MODEL 1302 <br /> . . - L 4 FLOW <br /> T1 AIGMT711REARB <br /> I fel BOTH ENDS��R� <br /> M f k tXA <br /> 1 <br /> Quad Rings O-ring <br /> P/N H B4 P/N H132 <br /> The Healy Model 1302 Flow Limiter is designed for installation into the female end of the Healy P/N <br /> 807 swivel breakaway before installation of a Healy Systems primary hose. The flow limiter reduces <br /> the product dispenser rate to conform to the U.S. EPA 10.0 gpm maximum dispensing limit. <br /> Installation Instructions: Lubricate the quad rings and O-ring before assembly with oil or grease. <br /> Do not use pipe sealant or tape on threads or seals. Install the male end of the flow limiter into <br /> the swivel breakaway as shown below and tighten to 35 to 70 ft-lbs. Install the primary hose and <br /> nozzle according to their instructions. Make sure all fittings are tight, test for any leaks and check to <br /> be sure the flow does not exceed 10.0 gpm with the nozzle fully open (lever held all the way up). <br /> Field replaceable parts are limited to replacement of the Quad Rings or O-ring. There is no <br /> maintenance required of the internal parts. <br /> , 1 <br /> i - <br /> ��h <br /> +R' <br /> 1- <br /> � R <br /> 4_ <br /> Nozzle 807 Swivel Flow Primary <br /> Breakaway Limiter Hose <br /> 7-1 <br /> GARB Approved IHM 7-Healy Flow Limiter Model 1302-Executive Orders VR-201 and VR-202 <br />