Laserfiche WebLink
1. PURPOSE: <br /> This procedure describes the tools, methods and skill levels required to install a Healy <br /> Systems, Inc. Model VP1000 Vapor Recovery pump in vapor ready Gilbarco Encore TM 300 <br /> and 500 series gasoline dispensers. Only Healy trained and certified contractors will be able <br /> to perform these retrofits or warranty will be void. The installer shall be a skilled petroleum <br /> technician and thoroughly familiar with the requirements of State, Federal and local codes for <br /> installation and repair of gasoline dispensing equipment. Also, they shall be aware of all the <br /> necessary safety precautions and site safety requirements to assure a safe and trouble free <br /> installation.NOTE: All electrical and hydraulic plumbing fittings referred to in these instructions <br /> must be UL "listed" or "recognized" for the purpose. <br /> Note: Installations of vapor piping into the inlet side of the vacuum pump should be sloped <br /> such that the natural flow direction is toward the vacuum pump. However, it is <br /> permissible to have a piping slope tilted away from the vacuum pump provided that all <br /> other applicable tests (Dispenser integrity and V/L) meet the specifications outlined in <br /> the appropriate section of the Executive Order and CARB Approved Installation, <br /> Operation and Maintenance Manual. <br /> Note: For installations with In-Station Diagnostics (ISD), the vapor flow meter shall be <br /> installed on the down stream side of the vacuum pump. Every effort shall be made <br /> to install the vapor flow meter so that vapor piping between the vacuum pump and <br /> the vapor flow meter is sloped such that the natural flow direction is toward the vapor <br /> flow meter. However, it is permissible to have the piping slope away from the vapor <br /> flow meter provided that all other applicable tests (Dispenser integrity, V/L and ISD <br /> Operability) meet the specifications outlined in the appropriate section of the <br /> Executive Order and CARB Approved Installation, Operation and Maintenance <br /> Manual. <br /> 2. SAFETY: <br /> Before installing the equipment, read, understand and follow: <br /> -The National Electrical Code (NFPA 70) <br /> -The Automotive and Marine Service Code (NFPA 30A) <br /> -Any national, state and local codes that may apply. <br /> The failure to install the equipment in accordance with NFPA 30A and 70 may adversely <br /> affect the safe use and operation of the system. <br /> Accurate, sound installations reduce service calls: Use experienced, licensed <br /> contractors that practice accurate, safe installation techniques. Careful installation <br /> provides a sound troubleshooting framework for field repairs and can eliminate potential <br /> problems. <br /> 1. Read all instructions before beginning. <br /> 2. Follow all safety precautions: <br /> ❑ Barricade the area. <br /> ❑ Do not allow vehicles or unauthorized people in the area. <br /> ❑ Do not smoke or allow open flames in the area. <br /> ❑ Do not use power tools in the work area. <br /> ❑ Wear eye protection during installation. <br /> 8-2 <br /> CARB Approved IOM 8-Gilbarco Encore 300 E 500 Series-Executive Orders VR-201 and VR-202 <br />