COMPLIANCE INFO_2021 - Laserfiche WebLink

Home Browse Search

1. PURPOSE: This procedure describes the tools, methods and skill levels required to install a Healy Systems, Inc. Model VP1000 Vapor Recovery pump in non-vapor ready GasboyTM model 9800 series gasoline dispensers. Only Healy trained and certified contractors will be able to perform these retrofits or warranty will be void. The installer shall be a skilled petroleum technician and thoroughly familiar with the requirements of State, Federal and local codes for installation and repair of gasoline dispensing equipment. Also, they shall be aware of all the necessary safety precautions and site safety requirements to assure a safe and trouble free installation. NOTE: All electrical and hydraulic plumbing fittings referred to in these instructions must be UL "listed" or "recognized" for the purpose. Note: Installations of vapor piping into the inlet side of the vacuum pump should be sloped such that the natural flow direction is toward the vacuum pump. However, it is permissible to have a piping slope tilted away from the vacuum pump provided that all other applicable tests (Dispenser integrity and V/L) meet the specifications outlined in the appropriate section of the Executive Order and CARB Approved Installation, Operation and Maintenance Manual. Note: For installations with In-Station Diagnostics (ISD), the vapor flow meter shall be installed on the down stream side of the vacuum pump. Every effort shall be made to install the vapor flow meter so that vapor piping between the vacuum pump and the vapor flow meter is sloped such that the natural flow direction is toward the vapor flow meter. However, it is permissible to have the piping slope away from the vapor flow meter provided that all other applicable tests (Dispenser integrity, V/L and ISD Operability) meet the specifications outlined in the appropriate section of the Executive Order and CARB Approved Installation, Operation and Maintenance Manual. 2. SAFETY: Before installing the equipment, read, understand and follow: - The National Electrical Code (NFPA 70) - The Automotive and Marine Service Code (NFPA 30A) -Any national, state and local codes that may apply. The failure to install the equipment in accordance with NFPA 30A and 70 may adversely affect the safe use and operation of the system. Accurate, sound installations reduce service calls: Use experienced, licensed contractors that practice accurate, safe installation techniques. Careful installation provides a sound troubleshooting framework for field repairs and can eliminate potential problems. 1. Read all instructions before beginning. 2. Follow all safety precautions: ❑ Barricade the area. ❑ Do not allow vehicles or unauthorized people in the area. ❑ Do not smoke or allow open flames in the area. ❑ Do not use power tools in the work area. ❑ Wear eye protection during installation. 3. Use circuit breakers for multiple disconnects to turn off power and prevent feedback from other dispensers. 2 CARB Approved IN B-Gilbarco Gasboy OBBO Series-Executive Orders VR-261 and VR-262