COMPLIANCE INFO_2021 - Laserfiche WebLink

Home Browse Search

❑ Leave the wires coming from the sealed nipple assembly at least six inches longer than necessary to reach the bottom of the compartment. Cut off excess and strip all wires 1/2". ❑ Connect the wires from the sealed nipple to the interface module as follows: ■ Black wire to `motor ` on module ■ White wire to `neutral' on module ■ Red wire (either) to `output Von module ■ Red wire (other) to `output 2' on module ■ Orange wire to `fault common' on module ■ Purple wire to `fault input' on module ■ Green wire needs a #8 ring tong lug installed and connected to any chassis ground (frame) ■ Some sealed nipples may have some extra wires, cap these and bundle them neatly out of the way. ❑ The black and white twisted pair of wires with a connector should be connected to an available AC outlet on the dispenser Relay Board #887225. ❑ The male/female multiconductor cable that is wired to the interface module is routed up to the computer board # 173976 (See Photo N). Disconnect the valves cable that's in the J3 connector and install in the female side of the double connector on the harness. The entire assembly is then installed back into J3 on the Computer board. WIRING IS COMPLETE. ❑ Mount the interface module as shown in Photo M using the 8-32 x 5/8" screw, washer and nut supplied in the electrical kit. ❑ Install the following labels supplied: • NOTICE label for current increase (1405), install on the frame rail near the existing power consumption label. • Large NOTICE label (1406) relating to the vapor recovery upgrade and how to reset the electronic module should be installed near the module, where it will be readily visible to a service technician on the junction box cover. • UL, retrofit kit identification number (1410), install on the electronic module. 13. CONNECTING HEALY SYSTEMS DISPENSING EQUIPMENT ❑ Completing the connection of Healy Systems dispensing equipment requires the installation of Healy Systems Phase II dispenser adaptors, hoses and nozzles (Hanging Hardware). ❑ If applicable, remove existing non-Healy hanging hardware (from the dispenser product outlet adaptor to and including the nozzles). ❑ Vapor ready dispensers will require a Healy Systems adaptor to make the hose threads compatible with other Healy Systems equipment. Install following instructions packed with the adaptor. Various adaptors and pigtails are available, depending on how the dispenser is configured: M34 metric (Healy designation F3 or S3) or balance ready (Healy designation S4). 8-12 GARB Approved IOM 8-Wayne Harmony Series(Balance)-Executive Orders VR-201 and VR-202