COMPLIANCE INFO_2021 - Laserfiche WebLink

Home Browse Search

MOTOR SPECIFICATIONS Horsepower 1/8 HP Voltage 120 VAC INTERFACE SPECIFICATIONS Input voltage 120 VAC Relay current capacity 5AAC Input signals AC and DC voltages up to 130 VAC max Motor Input signal 5 VDC @ 20 Hz 50% Duty Cycle 15. TESTING THE SYSTEM: - Carefully review all work completed, being sure all mechanical joints are thoroughly tightened and electrical connections sealed. - Open the product crash valves and restore power to the dispenser. - With the power on, but no nozzles authorized, the VP1000 should not be running (unless the ambient temperature is below 40°F), but the power LED (yellow) should be energized on the interface module. - Authorize one handle and the vacuum system should activate when the gasoline flow control valve is engaged. Repeat for all other nozzles, individually testing each nozzle on each side of dispenser. With each authorization, one of the green LED's on the interface module should illuminate and the VP1000 activate. - Note: For unihose dispensers, conduct individual tests for each product grade on each side of the dispener to ensure that the same LED activates for all grades on the same side. If the other LED activates, wiring needs to be corrected. - Authorize one nozzle and listen to the speed of the VP1000. With only one nozzle activated, the speed will be slower than if a nozzle on each side is activated. Activate a nozzle on the other side of the dispenser and listen for the speed to change. - To test the tightness of the vapor plumbing installed on the suction side of the system requires a 0-100" water column gauge. Connect the gauge into the 1/4" test port of the reducing tee installed earlier in section 10 Photo L. Continue by following and completing the START-UP / NEW INSTALLATION / WARRANTY /ANNUAL TESTING FORM. 8-15 CARE Approved IBM 8-Wayne Harmony Series(Assist)-Executive Orders VR-281 and VR-282