Laserfiche WebLink
13. WIRING INSIDE THE ELECTRONICS COMPARTMENT <br /> ❑ Cut the wires coming from the sealed nipple assembly in the electronics cabinet at least <br /> twenty inches long and strip all wires 1/2". <br /> ❑ Connect the wires from the sealed nipple to the interface module as follows: <br /> ■ Black wire to `motor ` on module <br /> ■ White wire to `neutral' on module <br /> ■ Red wire (either) to `output Von module <br /> ■ Red wire (other) to `output 2' on module <br /> ■ Orange wire to `fault common' on module <br /> ■ Purple wire to `fault input' on module <br /> ■ Green wire needs a #8 ring tong lug installed and connected to any chassis ground <br /> (frame) <br /> ■ Some sealed nipples may have some extra wires, cap these and bundle them neatly <br /> out of the way. <br /> ❑ The black and white twisted pair of wires with a connector should be connected to an <br /> available AC outlet on the dispenser Relay Board #887225 see photo T. <br /> ❑ The male/female multiconductor cable that is wired to the interface module is routed up to <br /> the computer board, J3. Disconnect the valves cable already in J3 and install in the female <br /> side of the double connector on the harness. The entire assembly is then installed back <br /> into J3 on the Computer board #173976 see photo T. <br /> ❑ Carefully position the wired module on the edge of the center upright sheet metal panel "B" <br /> side, select a blank hole, and slide over the 8-32 Tinnerman nut supplied in the electronics <br /> kit. Mount the module to the Tinnerman clip using the 8-32 x 5/8" screw and washer <br /> supplied. <br /> .1 <br /> r <br /> 1 <br /> air►'}''' rays <br /> IGEM COMPUTER <br /> BOARD. <br /> MODULE CABLE <br /> VALVES CABLE �1 - <br /> RELAY BOARD . .r <br /> EMPTY q <br /> LOCATIONS <br /> \Photo T <br /> 8-1E <br /> CARE Approved IOM 8-Wayne Ovation Series-Executive Orders VR-PDI and VR-202 <br />