Laserfiche WebLink
SANJ O A Q U I N Environmental Health Department <br /> COUNTY— <br /> Program 2 Prevention Program <br /> According to the California Code of Regulations (CCR),Title 19, Chapter 4.5, Article 2, Section 2740.1, if an RMP <br /> is required to be submitted, the owner or operator shall complete the required program 2 prevention program <br /> information below [CCR, Section 2745.6 (b)–(1)] and submit it with the RMP. If the same information applies to <br /> more than one covered process,the owner or operator may provide the information only once, but shall indicate <br /> to which processes the information applies. <br /> (b)The five or six digit NAICS code that most closely corresponds to the process: <br /> 49312 <br /> (c)The name(s) of the chemical(s) covered: <br /> Ammonia (anhydrous) <br /> (d)The date of the most recent review or revision of the safety information and a list of federal or state <br /> regulations or industry-specific design codes and standards used to demonstrate compliance with the <br /> safety information requirement: <br /> 3/21/2016 <br /> OSHA (29 CFR 1910.111) <br /> (e)The date of completion of the most recent hazard review or update: <br /> 3/21/2016 <br /> (1)The expected date of completion of any changes resulting from the hazard review: <br /> 2/18/2020 <br /> (2) Major hazards identified: <br /> Have seismic assessment conducted by licensed professional engineer. <br /> Annual check/test of high pressure shut-down pressure switch. <br /> (3) Process controls in use: <br /> Relief valves, check valves, manual shut-off valves, automatic shut-off valves, <br /> interlocks, alarms and procedures, and back up pumps <br /> 17 of 22 <br />