Laserfiche WebLink
LXeR and LXePR HOBART <br /> advansys HOT AND COLD 701 S Ridge Avenue,Troy,OH 45374 <br /> 1-888-4HOSART•www.hobartcorp.com <br /> SPECIFICATIONS <br /> DESIGN:Front opening,equipped for installation in either free- LXePR:Sanitation is accomplished by injection of proper <br /> standing or undercounter-type operations. amount of sodium hypochlorite solution(liquid bleach)into <br /> CONSTRUCTION:300 series stainless steel tank,door and top final rinse water to achieve a minimum of 5oPPM sanitizing <br /> panel. solution.Injection of sodium hypochlorite is accomplished <br /> PUMP:Centrifugal-type,tote rel with motor,horizontal) by a built-in sanitizing chemical pump.Minimum required hot <br /> 9 y water temperature is 120°F. <br /> mounted.Pump capacity 38 gpm. - Potable water rinse to remove chemical residue. <br /> MOTOR:Single phase,furnished for all electrical specifications. - To be used with sanitizer approved for use with post <br /> Factory sealed lubrication.Inherent overload protection with auto sanitizing rinse <br /> reset. <br /> WASH AND RINSE CYCLE:Complete automatic type,controlled CHECK WashSANIbutton <br /> CONCENTRATION:y thPurat thense must be <br /> off(hold Wash button for 5 seconds).Verify that there is suffi- <br /> by solid-state electronics.Cycle may be interrupted any time by cient chemical supply. Run cycle and use test trips on wetted <br /> opening door.Cycle continues when door is closed. surface of glasses after cycle is complete.If concentration is <br /> • Initial cycle fills wash tank,to be recirculated each wash cycle. below minimum required,contact your local Hobart Service <br /> Some wash water is drained off before rinse cycle.Rinse cycle office. <br /> refreshes wash water and tank heat. ENERGY RECOVERY:Heat energy is recovered from the con- <br /> RINSE PUMP:Powered by a single phase motor,the rinse pump densation of vapors in the chamber at the end of each cycle.This <br /> is made of high strength engineered composite material. pre-heats the water for the next rinse cycle from 55°F up to 140°F. <br /> BLOWER:The blower is a 60mm x 300mm tangential wheel PUMPED DRAIN:Machine automatically drains water through a <br /> powered by a 2-pole single phase motor for quiet and reliable built-in pump.Maximum 38"drain height permitted. <br /> operation,LXeR only. ELECTRIC BOOSTER HEATER:4.9 KW electric booster with <br /> CONDENSER COIL:The condensing system uses a tube and fin Sense-A-Temp'"technology adequately sized to raise 55°F inlet <br /> coil constructed of copper and corrosion resistant aluminum. water to 180°F,with the aid of the energy recovery system. <br /> The condenser coil allows for energy recovery from waste heat RACKING:Machines accommodate racks from 10"x 20"to 20"x <br /> in the moisture laden air that would normally escape into the 20".Also accepts 16"x 18"cafeteria trays. <br /> environment after a dishwashing cycle,LXeR only. NOTE:Certain materials,including silver,aluminum and pewter <br /> RINSE AND SANITATION: are attacked by Sodium Hypochlorite solution in the chemical <br /> • LXeR:Sanitation is accomplished by means of a built-in sanitizing mode of operation. <br /> booster heater designed to raise temperature of water to a SPECIFICATIONS:Listed by Underwriters Laboratories Inc.and <br /> minimum of 180°F from an Incoming water temperature of NSF International. <br /> 55°F. <br /> LXePR LXeR <br /> MACHINE RATINGS <br /> Light Normal Heavy Light Normal Heavy <br /> Racks per Hour Rate 38 29 14 30 24 13 <br /> Dishes per Hour(25 per Rack Avg.) 950 725 350 750 600 325 <br /> Glasses per Hour(36 per Rack Avg.) 1368 1044 504 1080 864 468 <br /> Controls Microcomputer <br /> Tank Capacity-Gallons 2.9 <br /> Overall Dimensions-H x W x D 3214"x 2316/"X 25e/,e" 32'A"x 2311Ae"x 26'3/,a" <br /> Cycle Time-Seconds 94 1 124 1 254 120 1 146 275 <br /> Tank Heat 1.8 KW <br /> Electric Booster Heater N/A 4.9 KW <br /> Water Usage Per Rack-Gallons 1.14 .62 <br /> Drain Design Pumped <br /> Door Opening Height 17" <br /> Detergent Pump Standard <br /> Rinse-Aid Pump Standard <br /> Delime Pump Standard <br /> Sanitizer Pump Standard I N/A <br /> Chemical Prime(auto prime) Standard <br /> Peak Drain Flow-GPM 4.0 <br /> Advanced Service Diagnostics Standard <br /> Advanced Cleaning Cycle Standard <br /> 70°Rise Sense-A-Temp"Booster Heater N/A Standard <br /> Incoming Water Temperature Required(minimum) 120° 55° <br /> As continued product Improvement is a policy of Hobart,specifications are subject to change without notice. <br /> Page 4 of 4 F40336-LXeR and LXePR advarr*Hot and Cold <br /> F40336(REV.03/13) 15186 LITHO IN U.S.A.(H-01) 10e,mueo"aayaa v"a, <br />