Laserfiche WebLink
D. Results of TestinglServicing <br />Software version Installed: _123.02 <br />Complete the following checklist: <br />In Section E below, describe how and when these deficiencies were or will be corrected. <br />E. Comments: <br />Monitoring System Certification <br />12/07 <br />2 2/21/07 <br />x <br />Yes <br />❑ <br />No <br />is the audible alarm operational? <br />x <br />Yes <br />❑ <br />No* <br />Is the visual alarm operational? <br />x <br />Yes <br />❑ <br />No* <br />Were all sensors visually inspected, functionally tested, and confirmed operational? <br />x <br />Yes <br />❑ <br />No* <br />Were all sensors installed at lowest point of secondary containment and positioned so that other equipment will <br />proper operation? <br />not interfere with their <br />❑ <br />Yes <br />❑ <br />x <br />No* <br />N/A <br />If alarms are relayed to a remote monitoring station, is all communications equipment (e.g. modem) operational? <br />x <br />Yes <br />❑ <br />❑ <br />No* <br />N/A <br />For pressurized piping systems, does the turbine automatically shut down if the piping secondary containment monitoring system <br />detects a leak, fails to operate, or is electrically disconnected? If yes: which sensors initiate positive shutdown? (Check all that apply) <br />❑ Sumpfrrench Sensors; ❑ Dispenser Containment Sensors. Did you confirm positive shutdown due to leaks and sensor <br />failure/disconnection? ❑ Yes; ❑ No. <br />❑ <br />Yes <br />❑ <br />x <br />No* <br />N/A <br />For tank systems that utilize the monitoring system as the primary tank overfill warning device (Le, no mechanical overfill prevention <br />valve is installed), is the overfill warning alarm visible and audible at the tank fill point(s) and operating properly? If so, at what percent <br />of tank capacity does the alarm trigger? % <br />❑ <br />Yes* <br />x <br />No <br />Was any monitoring equipment replaced? If yes, identify specific sensors, probes, or other equipment <br />manufacturer name and model for all replacement parts in Section E, below. <br />replaced and list the <br />❑ <br />Yes* <br />x <br />No <br />Was liquid found inside any secondary containment systems designed as dry systems? (Check all that apply) ❑ <br />es, describe causes in Section E, below. <br />Product; ❑ Water. If <br />x <br />Yes <br />❑ <br />No* <br />Was monitoring system set-up reviewed to ensure proper settings? Attach set up reports, if applicable <br />x <br />Yes <br />❑ <br />No* <br />Is all monitoring equipment operational per manufacturer's specifications? <br />In Section E below, describe how and when these deficiencies were or will be corrected. <br />E. Comments: <br />Monitoring System Certification <br />12/07 <br />2 2/21/07 <br />