INSTALL_2021 - Laserfiche WebLink

Home Browse Search

Bonded Sump Entry Fitting - Termination Style for Fuel Handling applications Installation and Application Instructions 1 . Determine entry hole location and cut entry hole in sump wall using appropriate "C " dimensions in Table 1 , 2. Using 40-60 grit fresh emery cloth or sand paper, sand de the sump ter of a alignment ings. outside, s theoutsidemust diameter of the alignment rings. All glazed surface must be removed. Once finished sanding, remove all dust 10000 from the sanded area with a clean , dry cloth or brush. A Do not use compressed air or bare fingers. ,. 3 . Place two alignment rings on sump entry fitting and insert through sump wall from outside the sump. Locate the 1/ inch threaded outlet to the desired angular location . - If this fitting is used in an Open (Drainage) System, w locate the 1/4 inch threaded outlet in the 6 o'clock position. Leave Y4 inch plastic threaded outlet protector in place System 3x2 Part No. 43 Part No. until 1/4 inch fitting installation. Red Thread IIA or 012030-626-0 012040-626-0 Dualoy 3000/1- 4, 000/L4. Dry fit primary pipe and rotate the two rings until the desired angle is reached. Maximum allowable offset is Dualoy 3000/LCX* 22856830 33856830 50. ' Includes Closure Nipple Make alignment marks on the rings, the sump entry fitting, and the sump wall . Be sure to mark the rings so they can be placed in the same location and sequence during bonding. TABLE I - Fitting SUMP WALL OUTSIDE Dimensions SUMP Size A B C INSIDE Inch Inch Inch Inch SUMP B A � 3 x 2 6.88 4.00 4.00 4 x 3 6.88 4.00 5.00 NOTE: These fittings can only be bonded to flat walled, T fiberglass sumps. DO NOT install on thermoplastic or D —f' round sumps. _ HOLE DIA RETAINING ALIONMENT � ENTRY TERMINATION FITTING BODY RING RINGS 0 ' Fiber Glass Systems