CORRESPONDENCE_1965-1989 - Laserfiche WebLink

Home Browse Search

Monitoring Well 3, (MW -3) located along the east side of the landfill near MW -2, (see Figure 2) was constructed on April 28, 1988. MW -3 was constructed in a 50 -foot -deep boring as follows: o Screen Section - 50 to 40 feet o Sand Pack - 50 to 35 feet No bentonite seal was placed in MW -3 because bentonite pellets were not available onsite at the time this well was constructed. This well was later removed and the boring backfilled with grout. 4.3 MONITORING WELL ABANDONMENT Hydro -Search decided to abandon the three monitoring wells shortly after their installation 'because no fluids or saturated sediments were encountered. On April 28, 1988, prior to construction of MW -3, Hydro -Search's geologist used a 1/2 inch diameter bailer to check for the presence of fluids in B-1, MW -1, and MW -2. No free fluids were detected. This information was communicated to Hydro -Search's Reno office for evaluation while MW -3 was being constructed. After MW -3 was constructed, Hydro -Search's field Is 104-88-683 6 Adilk Aft� IF W 114V k'q KLEINFELDER Hydro -Search had intended to place the grout seal after all the monitoring wells installed. This step was not required because MW -1 and all other monitoring wells were removed and the borings backfilled with grout. Monitoring Well 2, (MW -2) constructed on April 27, 1988, was located along ,the east side of the landfill (see Figure 2). MW -2 was constructed in a 20 -foot -deep boring as follows: o Screen Section - 20 to 10 feet o Sand Pack - 20 to 8 feet o Bentonite Seal - 8 to 5 feet This well was later removed and the boring backfilled with grout. Monitoring Well 3, (MW -3) located along the east side of the landfill near MW -2, (see Figure 2) was constructed on April 28, 1988. MW -3 was constructed in a 50 -foot -deep boring as follows: o Screen Section - 50 to 40 feet o Sand Pack - 50 to 35 feet No bentonite seal was placed in MW -3 because bentonite pellets were not available onsite at the time this well was constructed. This well was later removed and the boring backfilled with grout. 4.3 MONITORING WELL ABANDONMENT Hydro -Search decided to abandon the three monitoring wells shortly after their installation 'because no fluids or saturated sediments were encountered. On April 28, 1988, prior to construction of MW -3, Hydro -Search's geologist used a 1/2 inch diameter bailer to check for the presence of fluids in B-1, MW -1, and MW -2. No free fluids were detected. This information was communicated to Hydro -Search's Reno office for evaluation while MW -3 was being constructed. After MW -3 was constructed, Hydro -Search's field Is 104-88-683 6