Laserfiche WebLink
bKonMobil <br />Product Name: MOBIL DIE 26 <br />Revision Date: 15 Dec 2017 <br />Page 4 of 11 <br />Water spill and land spill recommendations are based on the most likely spill scenario for this material; <br />however, geographic conditions, wind, temperature, (and in the case of a water spill) wave and current direction <br />and speed may greatly influence the appropriate action to be taken. For this reason, local experts should be <br />consulted. Note: Local regulations may prescribe or limit action to be taken. <br />ENVIRONMENTAL PRECAUTIONS <br />Large Spills: Dike far ahead of liquid spill for later recovery and disposal. Prevent entry into waterways, <br />sewers, basements or confined areas. <br />SECTION 7 HANDLING AND STORAGE <br />HANDLING <br />Prevent small spills and leakage to avoid slip hazard. Material can accumulate static charges which may cause <br />an electrical spark (ignition source). When the material is handled in bulk, an electrical spark could ignite any <br />flammable vapors from liquids or residues that may be present (e.g., during switch-loading operations). Use <br />proper bonding and/or ground procedures. However, bonding and grounds may not eliminate the hazard from <br />static accumulation. Consult local applicable standards for guidance. Additional references include American <br />Petroleum Institute 2003 (Protection Against Ignitions Arising out of Static, Lightning and Stray Currents) or <br />National Fire Protection Agency 77 (Recommended Practice on Static Electricity) or CENELEC CLC/TR 50404 <br />(Electrostatics - Code of practice for the avoidance of hazards due to static electricity). <br />Static Accumulator: This material is a static accumulator. <br />STORAGE <br />The type of container used to store the material may affect static accumulation and dissipation. Do not store in <br />open or unlabelled containers. Keep away from incompatible materials. <br />SECTION 8 <br /> <br />EXPOSURE CONTROLS / PERSONAL PROTECTION <br />EXPOSURE LIMIT VALUES <br />Exposure limits/standards (Note: Exposure limits are not additive) <br />Substance Name Form Limit! Standard NOTE Source <br />2,6-DI-TERT-BUTYL-P-CRESOL Inhalable <br />fraction and <br />vapor <br />11/VA 2 mg/m3 N/A ACGIH <br />SEVERELY HYDROTREATED HEAVY <br />PARAFFINIC DISTILLATE <br />Mist. TWA 5 mg/m3 N/A ACGIH <br />Exposure limits/standards for materials that can be formed when handling this product: When mists/aerosols <br />can occur the following are recommended: 5 mg/m3 - ACGIH TLV (inhalable fraction), 5 mg/m3 - OSHA PEL. <br />NOTE: Limits/standards shown for guidance only. Follow applicable regulations. <br />No biological limits allocated. <br />ENGINEERING CONTROLS