COMPLIANCE INFO_2022 - Laserfiche WebLink

Home Browse Search

USES LR-BR is used as a protective coating to prevent water and corrosion damage. LR-BR can be used for rust protection of ferrous materials and is also of value for noise and vibration dampening. It may also be applied to concrete structures, slabs and parking decks. The high viscosity of LRBR allows it to be used to cover small cracks, or to coat vertical surfaces. APPLICATION LR-BR is water based environmentally safe alternative to conventional heat-applied or solvent based waterproofing systems. When cured it will form a seamless flexible membrane. LR-BR is a single component product that may be applied using a brush, roller or squeegee. It can also be poured on or spray applied using specially designed spray equipment. Since LR-BR cures by evaporation, an application temperature of 15 -40°C is recommended. Apply in thin coats. The product fully cures within 24 hours at 30°C and 50% relative humidity, when applied at a thickness of 1 mm. LR-BRshould be applied to a dry surface which is free of dirt, debris, oil or grease. Application is not recommended if heavy rains are imminent, or in high humidity environments. For best results apply in thin coats and leave to dry for at least 12 hours. Joints or cracks in the surface should be reinforced using LR Reinforcing Cloth. In high pressure areas use LR Extra Heavy Duty Reinforcing Cloth. Apply LR Activator Spray after final coat to set product and reduce tackiness. See application instructions or consult with an RTT Sealant representative for further details. LR-BR can be applied between 1.2 —4.2 L/m2 for a dry film thickness of 1 mm — 3mm protective membrane. Typically LR-BR dries to the touch in one minute @ 30°C and is completely cured in 48 hrs. This curing time may vary depending on temperature and relative humidity. LIMITATIONS LR-BR is mildly alkaline. When applying this product observe appropriate safety precautions, wear gloves, eye protection and other suitable protective equipment. For further information please consult the product MSDS. LR-BR should not be applied when the ambient temperature is below 15°C. The uncured membrane may be damaged if frozen. Do not apply to wet surfaces or directly before rain. Some surface base coat materials such as coal tar are unsuitable for use with LR-BR. CAUTION For industrial use only. Keep out of the reach of children. Avoid storage below 5°C. Please consult the Material Safety Data Sheet before using LR-BR. TECHNICAL SERVICE Call LR-BR PH:011 61 03-8812.2918 THIS PRODUCT IS NOT SUBJECT TO THE CONTROLLED PRODUCTS REGULATIONS. Prepared by: Liquid Rubber Melbourne Preparation date: 18 Feb 2014 Replaces: 18 May 2013 The information contained herein is based on available data and is provided for information only.Liquid Rubber Melbourne makes no warranties,guarantees or conditions,expressed or implied,regarding the accuracy of the data or its use thereof. Liquid Rubber Melbourne will not be liable for any damages arising from the use of the information,or product,described on this data sheet.