Laserfiche WebLink
Installation <br />Installation Procedure <br />3. Note which sensor cord grip entry is marked for the mini -hydrostatic Sensor on the label then remove the <br />cover of the Sensor Input Box and set it aside. Keep the o -ring in its groove in the inside of the cover. <br />4. Attach the connector end of the mini -hydrostatic Sensor's cable to the top of the sensor. Coil up and tie wrap <br />any excess cable. Get the cord grip bushing and nut from the sensor kit and slide them over the end of the <br />sensor cable (tapered end of bushing toward unit). <br />Figure 2. Sensor Input Box installation example <br />Legend for numbered boxes in Figure 2 <br />1. Mini -hydrostatic sensor <br />2. Use tie wraps to keep cables clear of sump components <br />3. Dispenser hydraulics cabinet <br />4. Top of pedestal island <br />5. Electrical conduit to TLS (customer supplied) <br />6. Position sensitive or sump sensor <br />7. Seal off and junction box (customer supplied) <br />8. Cord grip from install kit <br />9. 2 conductor shielded cable <br />10. Brine filled double wall dispenser sump <br />11. 2 to 1 Sensor Input Box <br />7 <br />