Laserfiche WebLink
D. Alternate construction for new underground storage tanks containing motor vehicles fuel (Section 26331 <br /> (1) Monitoring and response plan [Section 26341 . <br /> (2) underground storage tank composed of.... <br /> (a) Fiberglass reinforced plastic. <br /> (b) Cathodically protected steel. <br /> (c) Steel clad with fiberglass reinforced plastic. <br /> (d) Other material that complies with section 26 and 2632. <br /> (3) Floor of leak interception and detection system c structed on a firm base and sloped to a <br /> collection sump (use of membrane Liners comply with section 2631 (d) (6) requirements.) <br /> Access casings installed in the collection s � p of the secondary containment system with <br /> (4) <br /> backfill in the interstitial space. The ac ss casing shall meet all of the following: <br /> _ Designed and installed to allow the Liqui to flow into the casing. <br /> r Sized to allow removal of collected Li uid and able to withstand all anticipated applied <br /> stresses. <br /> _ Constructed of material that will of be structurally weakened. <br /> _ Screened along entire vertical ne of permeable material. <br /> _ Capable of preventing leakage of any hazardous substance from the casing. <br /> _ Extend to the ground surfa and covered with a locked waterproof cap. <br /> _ Capable of meeting S.J. o. PHS-EHD Well Standards. <br /> _ Leak interception and etection system shall prevent the Leaked hazardous substance from, <br /> entering ground Ovate . <br /> 14. INTERSTITIAL SPACE MONITORING <br /> A. Visual monitoring (Section 2632 c) (1)] <br /> (a) Exterior surface and f oor beneath tank monitored by direct viewing <br /> (b) Daily visual inspec ions <br /> (c) Liquid level in t nk to be recorded at time of inspection <br /> (d) If liquid obser ed around or beneath primary tank, owner will determine if an unauthorized releas <br /> has occurred. <br /> g, Mechanical or elect r nic monitoring (Section 2632 (c) (2)] <br /> (a) Continuou monitoring system connected to an audible and visual alarm system. <br /> Monitor ng equipment to\/be installed <br /> (f <br /> _V/ Manufacturer: <br /> \I t <br /> Model Number: TL S — 3 <br /> Sensor Type: _ Vapor VILiquid Both. <br /> _V/ Sensor/Panel specifications. <br /> Location s) fpr sen ors: C��1 <br /> Tank:S�tQvSt�c� otQ Piping: J " ' T"C <br /> Dispenser: 1i <br /> C. onitoring and response plan submitted [Section 2632 (d) (1) & (2)1- <br /> 15. <br /> Any special accessories, fittings, coatings, or linings not inherent within the initial design of the 1° tank or <br /> double-wall UST. [Section 2631 (b)] <br /> A. Approved by a nationally recognized independent testing organization. <br /> g Demonstration of integrity with the primary and/or secondary containment. <br /> 6 <br />