INSTALL_2001 - Laserfiche WebLink

Home Browse Search

Stage 11 Pipe Stage II Pipe Entries Stage II vapor recovery pipe entries must be field installed for both Custom Entry Boots. These four applications include both single and double wall pip- and Standard Dispenser Pans. There are four recommended applications for ing applications as well as non-functional stage II pipe entries. Note: Stage II accommodating stage II entries using either the Stage II Entry Kit or Flexible pipe entries must be installed after the Pipe Entry Boots. Application#1 Application #2 Application #3 Application#4 This application shows the Stage Il This application shows the Stage 11 This application shows the Stage II This application shows a 1"Flexible Entry Kit being installed with the 3 x Entry Kit being installed with both Entry Kit being installed for purpos- Entry Boot being installed to seal 2 rubber bushing for sealing directly the 3 x 2 and 1 x 2 rubber bushing es of capping-off the stage II vapor the 1"stage II vapor recovery pipe. to the 1-1/2"x 1"steel reducer bush- for sealing directly to 1" stage II recovery line for future use. This application does not permit ing. Permits connection of the Flexible recovery pipe. Permits connection Permits connection of the Flexible connection of the Flexible Isolation Isolation Tube. of the Flexible Isolation Tube. Isolation Tube. Tube. I '15) Flex Connector Isolation Installation Dispenser Pan Cuff Connections The rubber tube is sized so that it will seal to 3"nominal pipe and slide over this After primary pipe assembly and testing, shift the isolation tube up and over pipe so that the flexible connector may be visually inspected during testing. If the cuff located under the dispenser pan. Seal the lower and upper isolation sealing is required to 2" nominal pipe at the lower end,then use the 3" x 2" tube joints by installing the two band clamps and tightening each to 60 inch Rubber Reducer Seal which must be inserted onto the 2"pipe before assembly. pounds. The isolation tube may be individually tested to 5 psi using the air This size isolation tube is designed for dispenser pan connections. valve stem provided. I