COMPLIANCE INFO_2022 - Laserfiche WebLink

Home Browse Search

10'-20000 DWT6 Double -Wall Tank 19951 Gals DIPSTICK GALLONS DIPSTICK GALLONS CONTAINMENT S O L U T 1 O N S,, How To Properly Gauge Your Tank Underground storage tanks require periodic measurement to determine current inventory level. Using the proper methods when gauging your tank's contents will insure the most accurate reading and insure that you do not damage your tank. The following procedure should be followed whenever you use a gauge stick to determine the amount of product that is in your tank: 1) Use a wood dipstick with a rubber or nylon tip. Metallic dipsticks are not recommended. This will insure that frequent tank gaugings or an accidental dropping of the gauge stick into the tank will not damage the tank bottom. 2) Slowly lower your gauge stick into the fill port until it touches the tank bottom. Never free drop the gauge stick. This can result in inaccurate measurements due to product splashing. Free dropping can also result in gauge stick damage and tank damage. 3) Remove your dipstick slowly and read the product level directly from the gauge stick. Water Paste Detection To detect water in the tank bottom, water detection paste is available from petroleum equipment distributors. However, some water detection paste cannot detect antifreeze mixtures. If antifreeze mixtures are used for the cavity monitoring fluid, the following product is capable of detecting water or antifreeze (brine or up to 50 percent glycol) solution in the tank water bottoms: WATER FINDER #7686-1870 DAYCO/NATIONAL DAYTON, OH TEL: 1-800-283-2926 FAX: 1-800-688-4854 Caution Pressurized deliveries are not recommended. If the delivery vehicle uses pumps to fill the tank, install overfill shutoff equipment in the tank and truck to prevent the tank from being overfilled. Overfilling the tank under pressure will damage the tank even if the tank vent is unrestricted. Containment Solutions, Inc. 333 North Rivershire Dr., Suite 190 Conroe, TX 77304 Tel: 936-756-7731 Fax: 936-756-7766 Note: Calibration chart is based on the fluid level above a 5/16" deflector plate. 108 1/8 19059 114 1/8 19659 108 1/4 19074 114 1/4 19669 108 3/8 19088 114 3/8 19679 108 1/2 19103 114 1/2 19689 108 5/8 19117 114 5/8 19698 108 3/4 19131 114 3/4 19708 108 7/8 19146 114 7/8 19717 109 19160 115 19726 109 1/8 19174 115 1/8 19735 109 1/4 19188 115 1/4 19744 109 3/8 19202 115 3/8 19753 109 1/2 19215 115 1/2 19762 109 5/8 19229 115 5/8 19770 109 3/4 19243 115 3/4 19779 109 7/8 19256 115 7/8 19787 110 19270 116 19795 110 1/8 19283 116 1/8 19803 110 1/4 19296 116 1/4 19811 110 3/8 19310 116 3/8 19819 110 1/2 19323 116 1/2 19826 110 5/8 19336 116 5/8 19834 110 3/4 19349 116 3/4 19841 110 7/8 19361 116 7/8 19848 111 19374 117 19855 111 1/8 19387 117 1/8 19862 111 1/4 19399 117 1/4 19868 111 3/8 19412 117 3/8 19875 111 1/2 19424 117 1/2 19881 111 5/8 19436 117 5/8 19887 111 3/4 19448 117 3/4 19893 111 7/8 19460 117 7/8 19898 112 19472 118 19904 112 1/8 19484 118 1/8 19909 112 1/4 19496 118 1/4 19914 112 3/8 19508 118 3/8 19919 112 1/2 19519 118 1/2 19923 112 5/8 19530 118 5/8 19928 112 3/4 19542 118 3/4 19932 112 7/8 19553 118 7/8 19936 113 19564 119 19939 113 1/8 19575 119 1/8 19942 113 1/4 19586 119 1/4 19945 113 3/8 19597 119 3/8 19948 113 1/2 19607 119 1/2 19950 113 5/8 19618 119 5/8 19951 113 3/4 19628 113 7/8 19639 114 19649 Containment Solutions, Inc.