SR0085467_SSCRPT - Laserfiche WebLink

Home Browse Search

J' RESTRICTED MATERIALS PERMIT#39-20-3900248 Page 6 of 7 LOMBARDI FARMS, J Expires: 12/31/2020 regulations, label restrictions and other more restrictive conditions of this permit. 1. Maximum wind velocities for applications of Restricted Materials unless otherwise covered by the label, law, regulation,other permit conditions or environmental conditions at the application site are: a. Spray- 10 m.p.h. b. Dust-8 m.p.h. c. Pellets, granular or baits- 16 m.p.h. 2.Unless specifically named as a dust on this permit, NO DUST FORMULATIONS are allowed. 3.Apply pesticides covered by SLN(s)and Section 18(s)in conformance with the SLN(s)and Section 18(s).The SLN and/or Section 18 must be present at the use site along with the registered label. 4.A flagger is required at the application site for all AIR applications of Zinc Phosphide bait. 5.The applicator shall submit Notice of Intents(NOls)for any California Restricted Material to be used. NOIs will only be accepted electronically(CalAgPermits), in-person,or over the phone. NO NO]will be accepted by email or fax. NOls, in any submitted form,for weekend applications will NOT be accepted after 12:00pm Friday.Any California Restricted Material application proposed before 12:00pm Monday must have the corresponding NOI submitted no later than 4:00pm the prior Friday. EPA Registration Numbers for the proposed material to be used should be submitted on the NOI form. 6. For commodity fumigations,the term"Direct Supervision" is defined at minimum as a qualified applicator(holding a Department of Pesticide Regulation issued Qualified Applicator's Certificate(QAC)or Qualified Applicator's License(QAL) card, as the situation demands, in the subcategory"A")who is physically on-site during the application and initial aeration of the chamber. SITE CONDITIONS Appendix H Aluminum Phosphide and Magnes Aluminum Phosphide and Magnesium Phosphide for Burrowing Rodents See attached:Appendix H Q DICAMBA AND PHENOXY HERBICIDES CONDITION-Q- DICAMBA AND PHENOXY HERBICIDES—CENTRAL VALLEY In addition to all applicable laws, regulations and label restrictions,the CONDITIONS BELOW APPLY to applications covered by this permit. 1. No ester formulation applications allowed. 2. Do not discharge material more than 10 feet above the crop or target, 3.A drift reducing agent shall be added to the spray mixture at label rates. 4. Maximum wind velocity for Phenoxy herbicides-10 m.p.h. 5. Maximum wind velocity for Dicamba is 10 m.p.h. EXCEPT when wind is moving in direction of sensitive crops,then the maximum wind velocity is 5 m.p.h. QL DICAMBA AND PHENOXY HERBICIDES CONDITION-QL-DICAMBA AND PHENOXY HERBICIDES-North of Eight Mile Road In addition to all applicable laws, regulations and label restrictions, the CONDITIONS BELOW APPLY to applications covered by this permit. 1. No ester formulation applications allowed.