_O & M MANUAL - WEST LANE MOBILE HOME PARK

Home Browse Search

SAFETY FIRST! 'Please Read This Before Installing Or Operating Pump. This information is provided for SAFETY and to PREVENT EQUIPMENT PROBLEMS. To help recognize this information, observe the following symbols: IMPORTANT! Warns about hazards that can result Ain personal injury or Indicates factors concerned with !9 assembly, installation, operation, or maintenance which could result in damage to the machine or equipment if ignored. CAUTION ! Warns about hazards that can or will cause minor personal injury or property damage if ignored. Used with symbols below. WARNING I Warns about hazards that can or will cause serious personal injury, death, or major property damage if ignored. Used with symbols below. Hazardous fluids can FILExtremely hot - Severe cause fire or explo- bumes can occur on contact. sions. bumes or death could result. i Hazardous fluids can Hazard - Biohazard can cause �� _. ous pressure. eruptions or ex- a serious personal injury. plosions could cause personal injury or property damage. Rotating machinery Amputation or severe Hazardous voltage can laceration can result. shock, turn or cause death. Only qualified personnel should install, operate and repair pump. Any wiring of pumps should be performed by a qualified electrician. WARNING ! - To reduce risk of electrical shock, pumps and control panels must be properly grounded in accordance with the National Electric Code (NEC) or the Canadian Electrical Code (CEC) and all applicable state, province, local codes and ordinances. WARNING! - To reduce risk of electrical shock, always disconnect the pump from the power source before handling or servicing. Lock out power and tag. IdU ' WARNING! Operation against a closed discharge valve will cause premature bearing and seal failure on any pump, and on end suction and self priming pump the heat build may cause the generation of steam with resulting dangerous pressures. It is recommended that a high case temperature switch or pressure relief valve be installed on the pump body. CAUTION ! Never operate a pump with a plug-in type power cord without a ground fault circuit interrupter. I €apt CAUTION! Pumps build up heat and pressure during operation -allow time for pumps to cool before handling or servicing. WARNING! - DO NOT pump hazardous materials (flammable, caustic, etc.) unless the pump is specifically designed and designated to handle them. As Do not block or restrict discharge hose, as discharge hose may whip under pressure. WARNING! - DO NOT wear loose clothing that may — become entangled in the impeller or other moving parts. WARNING! - Keep clear of suction and discharge openings. DO NOT insert fingers in pump with power connected. Always wear eye protection when working on pumps. Make sure lifting handles are securely fastened each time before lifting. DO NOT operate pump without safety devices in place. Always replace safety devices that have been removed during service or repair. Secure the pump in its operating position so it can not tip over, fall or slide. DO NOT exceed manufacturers recommendation for maximum performance, as this could cause the motor to overheat. DO NOT remove cord and strain relief. Do not connect conduit to pump. WARNING! Cable should be protected at all times to avoid punctures, cut, bruises and abrasions - inspect frequently. Never handle connected power cords with wet hands. WARNING! To reduce risk of electrical shock, all wiring and junction connections should be made per the NEC or CEC and applicable state or province and local codes. Requirements may vary depending on usage and location. 1JWARNING! Submersible Pumps are not approved for use in swimming pools, recreational water installations, decorative fountains or any installation where human contact with the pumped fluid is common. WARNINGI Products Returned Must Be Cleaned, Sanitized. Or Decontaminated As Necessary Prior To Shipment, To Insure That Employees Will Not Be Exposed To Health Hazards in Handling Said Material. All Applicable Laws And Regulations Shall Apply. Bronzelbrass and bronze/brass fitted pumps may '.X contain lead levels higher than considered safe for potable water systems. Lead is known to cause cancer and birth defects or other reproductive harm. Various government agencies have determined that leaded copper alloys should not be used in potable water applications. For non-leaded copper alloy materials of construction, please contact factory. IMPORTANT! - Crane Pumps & Systems, Inc. is not Aresp!A onsible for losses, injury, or death resulting from a failure to observe these safety precautions, misuse or abuse of pumps or equipment.