Laserfiche WebLink
12115/2016 Standards catalog <br /> b ) Sump use (enclosed tank, transition or dispenser types) when connected to pumps , <br /> valves, monitors , or dispensing devices with expected exposures to soil , water, soil fluids, <br /> and occasional sunlight; <br /> c) Aboveground use (above surface but with additional physical protection ) when <br /> connected to aboveground tanks or aboveground pipes with expected exposures to soil , <br /> STANDARDSSearch Standards <br /> the expected use conditions, and exposures that have s'im'ilar chemical, physical and inateria( <br /> compatibility properties as represented in these requirements based on fuels formulated in accordance <br /> with 40 CFR Part 80, Regulation of Fuels and Fuel Additives , and meeting the following ASTM Fuel <br /> Specifications and blend limitations: <br /> a ) ASTM D -975, Standard Specification for Diesel Fuel Oils, with biodiesel blends up to <br /> a maximum of 5 percent ( 135) ; <br /> b ) ASTM D -7467 , Standard Specification for Low Blend Biodiesel , with biodiesel blends <br /> between 6 to 20 percent ( B6 to B20). <br /> c) ASTM D -4814, Standard Specification for Automotive Spark- ignitlon Engine Fuel , <br /> gasoline or oxygenated gasoline , with limited ethanol blends up to a maximum of 10 <br /> percent ( E10) . <br /> d) ASTM D -5798 , Standard Specification for Ethanol Fuel Blends for Flexible-Fuel <br /> Automotive Spark•• ignition Engines , high blend ethanol, with gasoline/ethanol mixtures in <br /> the ( E51 - E83 ) range. <br /> e) Mid Range Ethanol Blends ( E11 to E50 ) using variable mixtures of ASTM D4814 Low <br /> Blend Ethanol and ASTM D5798 High Blend Ethanol . <br /> f) Isobutanol Fuel Blends ( max iBu16) using variable mixtures of ASTM D4814 Gasoline <br /> (EO )�and ASTM D7862 Butanol (2-methyl- l -propanol isomer) . <br /> 1 .4 Products covered by this outline are intended to be installed and used in accordance with : <br /> a) Flammable and Combustible Liquids Code, NFPA 30 , <br /> b) Code for Motor Fuel Dispensing Facilities and Garages, NFPA 30A, <br /> c) Uniform Fire Code , NFPA 1 , <br /> d ) International Fire Code published by the International Fire Council , or <br /> e ) Other applicable federal and state regulations for piping . <br /> 1 . 5 These products are factory manufactured and intended for on-site field assembly, inspection , and <br /> leak testing for the specified applications and use conditions by qualified persons in accordance with the <br /> manufacturer's instructions and local requirements. <br /> 1 .6 These products are intended to be periodically inspected and maintained for continued service , or <br /> taken out of service if necessary, by qualified persons in accordance with industry recommended <br /> practices and/or the manufacturers instructions. P <br /> httpsl/standardscatalog,ul .com/standards/eWstandard 2039 1 �� <br />