COMPLIANCE INFO_2023 - Laserfiche WebLink

Home Browse Search

10'-12000 DWT6 Double -Wall Tank 11873 Gals DIPSTICK GALLONS DIPSTICK GALLONS CONTAINMENT $ 0 L U T 1 0 N S® HOW TO PROPERLY GAUGE YOUR TANK: Underground storage tanks require periodic measurement to determine current inventory level. Using the proper methods when gauging your tank's contents will insure the most accurate reading and insure that you do not damage your tank. The following procedure should be followed whenever you use a gauge stick to determine the amount of product that is in your tank: 1) Use a wood dipstick with a rubber or nylon tip. Metallic dipsticks are not recommended. This will insure that frequent tank gaugings or an accidental dropping of the gauge stick into the tank will not damage the tank bottom. 2) Slowly lower your gauge stick into the fill port until it touches the tank bottom. Never free drop the gauge stick. This can result in inaccurate measurements due to product splashing. Free dropping can also result in gauge stick damage and tank damage. 3) Remove your dipstick slowly and read the product level directly from the gauge stick. Water Paste Detection To detect water in the tank bottom, water detection paste is available from petroleum equipment distributors. However, some water detection paste cannot detect antifreeze mixtures. If antifreeze mixtures are used for the cavity monitoring fluid, the following product is capable of detecting water or antifreeze (brine or up to 50 percent glycol) solution in the tank water bottoms: WATER FINDER #7686-1870 DAYCO/NATIONAL DAYTON, OH TEL: 1-800-283-2926 FAX: 1-800-688-4854 Caution Pressurized deliveries are not recommended. If the delivery vehicle uses pumps to fill the tank, install overfill shutoff equipment in the tank and truck to prevent the tank from being overfilled. Overfilling the tank under pressure will damage the tank even if the tank vent is unrestricted. Containment Solutions, Inc. 333 North Rivershire Dr., Suite 190 Conroe, TX 77304 Tel: 936-756-7731 Fax: 936-756-7766 Note: Calibration chart is based on the fluid level above a 5/16" deflector plate. 108 1/8 11379 114 1/8 11716 108 1/4 11387 114 1/4 11721 108 3/8 11395 114 3/8 11726 108 1/2 11404 114 1/2 11732 108 5/8 11412 114 5/8 11737 108 3/4 11420 114 3/4 11742 108 7/8 11428 114 7/8 11747 109 11436 115 11752 109 1/8 11444 115 1/8 11757 109 1/4 11452 115 1/4 11762 109 3/8 11460 115 3/8 11767 109 1/2 11468 115 1/2 11772 109 5/8 11475 115 5/8 11776 109 3/4 11483 115 3/4 11781 109 7/8 11491 115 7/8 11786 110 11498 116 11790 110 1/8 11506 116 1/8 11794 110 1/4 11513 116 1/4 11799 110 3/8 11521 116 3/8 11803 110 1/2 11528 116 1/2 11807 110 5/8 11535 116 5/8 11811 110 3/4 1 11543 116 3/4 11815 110 7/8 11550 116 7/8 11818 111 11557 117 11822 111 1/8 11564 117 1/8 11826 111 1/4 11571 117 1/4 11829 111 3/8 11578 117 3/8 11833 111 1 /2 11585 117 1 /2 11836 111 5/8 11592 117 5/8 11839 111 3/4 11599 117 3/4 11842 111 7/8 11605 117 7/8 11845 112 11612 118 11848 112 1/8 11619 118 1/8 11851 112 1/4 11625 118 1/4 11854 112 3/8 11632 118 3/8 11856 112 1/2 11638 118 1/2 11859 112 5/8 11644 118 5/8 11861 112 3/4 11651 118 3/4 11863 112 7/8 11657 118 7/8 11865 113 11663 119 11867 113 1/8 11669 119 1/8 11868 113 1/4 11675 119 1/4 11870 113 3/8 11681 119 3/8 11871 113 1/2 11687 119 1/2 11872 113 5/8 11693 119 5/8 11873 113 3/4 11699 113 7/8 11704 114 11710 Containment Solutions, Inc.