Laserfiche WebLink
B-27 Compression Fitting - VAPOR <br /> You do not need to worry about the B-27 fitting body <br /> dropping down or falling through the bottom of the shallow <br /> pan if the vapor line is threaded into the top of this fitting. If a <br /> smaller line is passing through it however, it may drop down <br /> and out so use caution and secure the body above the floor <br /> as you loosen the nut to test it. <br /> After cleaning all contact areas thoroughly, use vulkem to <br /> seal between the nut and flat gasket and also to the exposed <br /> threads of the body. Do not apply vulkem between the flat <br /> FLAT GASKET gasket and the floor of the shallow pan or dislodge this <br /> VULKEM gasket. Lubrication can cause it to slip loose or pinch once <br /> tightened causing a leak point. <br /> FREQUENTLY ASKED QUESTIONS: <br /> How do I clean up a dirty B2000 or address corrosion? <br /> A) Dust, blow out and/or vacuum any dry debris from the interior. <br /> B) Vacuum out any liquids, debris, gunk, etc.. <br /> C) Protect any exposed test ports or threads, remove any electronic sensors. FOR MORE FAQ <br /> D) Use Acetone to clean the surfaces so a visual inspection can be made. <br /> E) Scrape the bottom and/or walls with a flat-blade tool. Re-vacuum. <br /> F) Lightly sand all areas where the factory epoxy-paint is missing. a- <br /> G) Coat any exposed steel with AmerShield, overlapping remaining factory paint. <br /> 1 <br /> How do I test / maintain the mechanical float system? <br /> A) Follow steps A-D above. <br /> a <br /> B) Remove all mechanical float trip components. <br /> When removing the float arm actuator- USE CAUTION! the sleeve that holds the SCAN CODE <br /> float arm in place may be weak or corroded. If it breaks, contact the factory for a <br /> Retrofit Float Arm assembly. SBRAVO.COM/FAQ <br /> C) Clean the float cup reservoir interiors and replace all float trip components. <br /> D) Re-connect the float trip chain to the trip arm on the shear valve. <br /> E) Slowly add water to each cup until it trips the shear valve. <br /> F) If the water does not trip the float, check to see if it is binding. Pull up by the stem <br /> to determine if it is stuck or cannot rise smoothly.Adjust components as necessary. <br /> G) If it can freely move vertically but water does not trip it or rises above the top, <br /> contact the factory to order a replacement. NOTE: Only round floats are available. <br /> LIMITED WARRANTY <br /> All containment systems sold by S.Bravo Systems,Inc.are warranted to be free from defects in material and workmanship for a period of one year from date of purchase. <br /> This warranty will be limited to the repair and replacement of Bravo parts only and will exclude all claims for labor or consequential damage.No other express warranties <br /> given and no affirmation of S.Bravo Systems,Inc.,or its agents and/or representatives,by words or action,will constitute a warranty.IT IS EXPRESSLY AGREED THAT <br /> THIS WARRANTY WILL BE IN LIEU OF ALL WARRANTIES OF FITNESS AND IN LIEU OF THE WARRANTY OF MERCHANTABILITY. <br /> This warranty is void if there is any evidence of modification,abuse,negligence,or improper installation. If any fittings or components,other than S. Bravo Systems <br /> approved fittings or components,are used in conjunction with any S.Bravo Systems product,the warranty pertaining to these products is immediately void. <br /> 4 ii-B2000-RETROFIT-KIT-14A <br />