INSTALL_2023 - Laserfiche WebLink

Home Browse Search

Bonded Sump Entry Fitting - Termination Style for Fuel Handling applications Installation and Application Instructions 1. Determine entry hole location and cut entry hole in sump wall using appropriate"C"dimensions in Table 1. 2. Using 40-60 grit fresh emery cloth or sand paper, sand the sump wall surfaces,inside and outside,to the outside diameter of the alignment rings.All glazed surface must be removed. Once finished sanding, remove all dust from the sanded area with a clean, dry cloth or brush. s� Do not use compressed air or bare fingers. 3. Place two alignment rings on sump entry fitting and insert through sump wall from outside the sump. Locate ; the 1/4 inch threaded outlet to the desired angular location. -` If this fitting is used In an Open (Drainage) System, locate the 1/4 Inch threaded outlet in the 6 o'clock position. system 3x2 Part No. 1.4x� Leave ' inch plastic threaded outlet protector in place /4 r ° until '/4 inch fitting installation. Red Thread IIA or 012030-626-0 012040-626-0 Dualoy 3000/1- 4. Dry fit primary pipe and rotate the two rings until the Dualoy 3000/LCX` 22856830 33856830 desired angle is reached. Maximum allowable offset is 50. Includes Closure Nipple Make alignment marks on the rings, the sump entry fitting, and the sump wall. Be sure to mark the rings so they can be placed in the same location and sequence during bonding. SUMP WALL OUTSIDE SUMP Size A B C INSIDE A Inch Inch Inch Inch SUMP 3 x 2 6.88 4.00 4.00 B 4 x 3 6.88 4.00 5.00 00 NOTE:These fittings can only be bonded to flat walled, _ _ C — fiberglass sumps.DO NOT install on thermoplastic or C T round sumps. HOLE DIA -1 — � Z _ ENTRY TERMINATION RETAINING ALIGNMENT FITTING BODY RING RINGS IS Fiber Glass Systems