Laserfiche WebLink
Appendix B H&S Energy#3034 / Diesel product DT <br /> 71SO Overfill Valve In Tank Shut Off Level <br /> Worksheet <br /> Important: This is meant to be a supplemental <br /> worksheet and not a substitute to following the <br /> installation manual instructions. All length <br /> measurements are in inches. Please contact the <br /> Authority Having Jurisdiction (AHJ) and review <br /> local, state, and national codes to determine the <br /> regulatory requirements governing shut-off <br /> capacity in your region, as well as take into <br /> account other considerations such as extreme <br /> tank tilt. ( ) <br /> Upper <br /> With valve installed in the tank take the following Tube <br /> measurements: Ler iigth <br /> Distance from the 71 SO inlet tube flange to the cast <br /> lug in the 71 SO body (see figures), upper tube <br /> length. Note: the Upper Tube Length must be at ( ) <br /> least 16" to include the protective bend in the tube. Va ve <br /> (D) = 44.25 Len gth, <br /> bottc m of <br /> ct <br /> Distance from the 71 SO inlet tube flange to the ( ) <br /> bottom of the tank. Note: If a tank bottom protector To ank <br /> is present it may be necessary to add this thickness Boitorn <br /> to dimension (OPW 6111 & 61TP models add 0.6") ( ) <br /> T nk <br /> (B) = 131.25 (U) alve Chart <br /> From the tank calibration chart provided by tank <br /> Length, 1010% <br /> manufacturer find the dipstick number (Y) which top f Vol me <br /> o CA Dipstick <br /> corresponds to the 100/o volume. Di ber <br /> (Y) = 8021 <br /> 1. To determine shut-off percentage: <br /> Subtract upper tube length (D)from distance to <br /> tank bottom (B) <br /> (X) = (B) — (D) -2" = 85 <br /> Using the tank calibration chart provided by the Note: The overfill valve must be installed per AHJ <br /> tank manufacturer determine the tank capacity at requirements and all applicable local, state, and <br /> the calculated (X) dimension and the 100% volume national codes. If overfill valve is set above the <br /> (Y)tank capacity. allowable shut-off percentage the overfill valve <br /> must be removed and replaced. For reference 40 <br /> (X) tank capacity in gallons = 7528 CFR part 280 Subpart B Section 280.20 overfill <br /> valves should be set to a maximum of 95%. <br /> (Y) tank capacity in gallons = 8021 <br /> SO% _ (X) capacity/ (Y) capacity x 100 = 93.85 <br />