Laserfiche WebLink
11' Square Centered <br />Perimeter of Griddle <br />on Griddle Center <br />11" square centered on <br />module center <br />Point of Intersection <br />AIM POINT <br />11'Square <br />Centered on <br />Griddle Center <br />48" max. <br />. <br />.0.° 24" max. <br />11( 30. MaL 15" mm. ' <br />4 l <br />Note: Maximum & minimum <br />heights must be measured from <br />the tip of nozzle to the surface <br />of the appliance. <br />AP 2" NDIX A- 'age 31 of 49 <br />\ I / <br />December zooa Section 3 Kp Design —15 <br />Amerex Restaurant Fire Sup pressiorf ystern 4658) <br />GRIDDLE PROTECTION - LARGE <br />TWO (2) FLOW POINT NOZZLE (P/N 14178) <br />11' Square Centered <br />on Griddle Center <br />The Amerex Range Nozzle (P/N: 14178) has two (2) <br />flow points and will protect a griddle surface of 48 <br />inches wide (122 cm) x 30 inches deep (76 cm). The <br />nozzle must be located along the perimeter of the <br />appliance and within a vertical height range from 24" <br />(61 cm) to 50" (127 cm) above the surface of the <br />appliance. The aiming point for the nozzle is the <br />"Point of Intersection" of a straight line from the <br />nozzle location to the center of the appliance, where <br />the line crosses the outer edge of an 11 inch square <br />(28 cm sq.), centered over the center point of the <br />griddle. <br />Perimeter of Griddle <br />Note: maximum & minimum <br />heights must be measured <br />from the tip of nozzle to the <br />surface of the appliance. <br />11" square centered <br />on griddle's center <br />Point of Intersection <br />AIM POINT <br />Ncomle Location <br />GRIDDLE PROTECTION - LOW PROXIMITY <br />TWO (2) FLOW POINT NOZZLE (P/N 14178) <br />The Amerex Range Nozzle (P/N: 14178) has two (2) flow points and <br />will protect a griddle surface of 48 inches wide (122 cm) x 30 inches <br />deep (76 cm). The nozzle must be located at any one of the four <br />corners of the appliance and within a vertical height range from 15" <br />(38 cm) to 24" (61 cm) above the surface of the appliance. The <br />aiming point for the nozzle is the "Point of Intersection" of a <br />straight line from the nozzle location to the center of the appliance, <br />where the line crosses the outer edge of an 11 inch square (28 cm <br />sq.), centered over the center point of the griddle. <br />Nozzle Location