COMPLIANCE INFO_2024 - Laserfiche WebLink

Home Browse Search

STEP i3: DIMPLE FIRST HOLE Remove toot. Remove any chips or burrs from rhe drill- ing operation. Place the assembly on a solid surface. using the punch supplied with the MSD 1001, 715b - Tom. and 7150-701) T, align the tip of the punch with the drilled bare and dimple rite upper drop tube by striking the punch with a hammer until the drop tube is formed into countersunk (tole in the inlet tube. After purxhing, remove any chVs that may have fallen into the inlet Whe screw hole, Figvrr 13 STEP 14: ASSEMBLE AR5T SCREW Ensure that the drop tube was formed into thPCW mer sunk screw hole as shown In Figure 14 if not return to Step 13. Apply black moiy grease to Screw and tighten first screw Into Inlet tutu with a screwdriver, use only the taptite screws that are supplied with the unit Seat- iN torque is ao illAM min. to 3S ir>`Ibs rna>c Screw head should be Rush wlththedroptube, Vonatovertlght- en. Vwwdwdno�lebfo�,Y tae 0M`f.+l�ew ilyvr'd f�f 51 is: Dilmibu REMAINING HOLES Remove any chips of burrs (tarn the drillingoperation, D mple the next (2) holes as dyne in Step 13, Make vire the assembiy is on a solid surface when punchirtg.. After punchinm remove any chips that may have fallen into the mitt tube Snow hole. Align punch with drilled hole Figure t5 51 EP 16: ASSEMw E OTHER SCIlM Apply black molt' grease to screws and tighten the ath- er (2) screws into inlet tube with a screwdriver as done in Step 14. Use only the septile screws that are supplied with ttm unit. Stating torque is 20 in-Itx min. to 35 in,, lbs max. Do not over tighten. S1EP 17: AppLY t:HEASE7t) LO1N�t t)-pIiIG AND EDDY THREADS Apply black cooly grease to the lower tube erring and 6ady threads as shown. Make sure coverage is carry pletely around the o -ring. Install o•rirxj in groove just al uve threads. Applygreese arourdc*ring " Offing" �� 9'°o're &adytl;r�+sCs Ffgnrr 17 I1