Laserfiche WebLink
STEP 13: DIMPLE FIRST HOLE <br />Remove tool. Remove any chips or burro from tfte drIW <br />ing operation. Place the asseln51Y on a solid surface, <br />using the punch supplied with the 7150-TOO4, 71 St} <br />TO(uC, and 7150.70OLCro align the tip of the punch <br />with thedrtNed hale and dimple Itte upper drop tube by <br />SU!Wng the punch with a hammer until thedrop tube is <br />formed into countersunk hole in the inlet tube. After <br />purxhing, remove any chips that may have fallen into <br />the inlet wbe strew hole. <br />Figvrr t3 <br />"90 '14P <br />ASSEMBLE F1p5T SCREW <br />Ensure that the drop tube was farnud into tha coumter <br />sunk Screw hole as shown In Figure 14 if not rertum (o <br />Step 13. Apply black mo{y grease to screw and tighten <br />first screw intu Inlet tube with a screwdriver. Use only <br />the tapttre screws that are supplied with the unit Seat• <br />ing torque is 20 inAtK min, to 35 in-{bs marc Screw head <br />should be flush with the drop tube, Vo nal over tight- <br />en, <br />sfQure ti <br />5TEP 1 s: DIMPLE REMAINING HOLES <br />Remove any chips or buns from the driUingoperatk>n. <br />D nple the next (2) holes as dome in Step 13. Make sure <br />the assembly is on a solid surface when punchi mg. After <br />punchirxy remove any chips that may have fallen into <br />rhe inter tube crew hole. <br />Align punch with, <br />drilled hole <br />FfQusr TS <br />STFP 16: ASSSMOs E OTHER SCREws <br />Apply black moly grease to screws and tighten the oth- <br />er (2) screws into inlet tube with a screwdtiver as done <br />in Step 14, Use only the taptite strews that ars supplied <br />with the unit. Scaring torque Is 20 in dbx min. to 35 im <br />Ibs max, Do not over tlghten. <br />STEP 17: APPLY t;HEASE70 LUWiDI O -#IMG AND <br />BOGY Tllol A S <br />Apply black moiy grease to the lower tube o -ring and <br />body threads as shown. M*e sum coverage is torn- <br />piMely around the o ring. install o -ilial in grtxwe just <br />ave threads. <br />A PPhr 9rea se <br />around raring <br />F7gwit iT <br />n <br />