Laserfiche WebLink
Support Surface Depth (C) - Support surface should be approximately 460 mm <br /> (18 in) Jeep. Allow at least 51 mm (2 in) clearance behind the sterilizer for air <br /> circulation. <br /> Distance To Side Wall (D) - If the sterilizer is located next to side walls, there <br /> should be no less than 51 mm (2 in) clearance between the side of the sterilizer <br /> Installation <br /> and the wall. <br /> Distance Above Sterilizer (E) - If the sterilizer is to be located beneath wall cabi- <br /> nets or shelves, the underside of the cabinets or shelves should be at least 559 <br /> mm (22 in) above the support surface, to provide access to the top inspection <br /> cover end to allow for changing the printer paper roll. <br /> Overhe nQ (F) - If the sterilizer is to be located beneath an overhang, the under- <br /> side of the overhang should project no further than 381 mm (15 in) over the rear <br /> of the sterilizer. <br /> Locatic n On Support Surface -The front of the sterilizer should be located near <br /> the front of the support surface so water can be easily drained from the tube into <br /> a container. <br /> Neighboring Materials and Equipment - If the sterilizer will be operated in con- <br /> tinuous cycles, locate the sterilizer where excessive emission of steam will not <br /> damage materials or equipment in the surrounding area. <br /> Re-Location Requirements For Sterilizer <br /> 1. Disvonnect power cord from the electrical outlet and allow sterilizer to cool. <br /> 2. Drain water from reservoir or take care not to tip the sterilizer, which will <br /> allow water to spill from reservoir. <br />