Laserfiche WebLink
REMOVE THIS <br />CUT HERE <br />Iwo Cc:52, <br />Fig. 2: Ring with Threaded Screw Hole Inserts <br />Fig. 2a <br />LIKE THIS <br />CONCRETE INSTALLATION INSTRUCTIONS <br />Turn off all power to pool or spa and pump systems. <br />Installation is easiest when pool or spa is drained. <br />CAUTION DRAINING A POOL OR SPA MAY <br />CAUSE STRUCTURAL DAMAGE. BEFORE <br />DRAINING CONTACT YOUR LOCAL LICENSED <br />POOL BUILDER OR REMODELER. <br />Remove existing drain cover (Fig. 1). <br />Determine from the following choices which <br />provided screws, fasteners, and spacers to use to <br />attach the drain cover support plate to the pool or <br />spa surface. <br />3a If the pool or spa surface has an embedded ring <br />around the suction pipe, which ring has threaded <br />screw hole inserts, use the provided two 8-32x3/4 <br />screws (Fig. 2). Use the appropriate provided <br />spacers A or B (Fig. 9 -- see Pg 6) (small end up) <br />to close the gap between the drain cover support <br />plate and the embedded ring. For example, if you <br />are replacing a Pentair drain cover use spacer <br />B.275; if you are replacing a Waterway drain cover <br />use spacer A.250. If you have an AFRAS ABF <br />Series drain (See steps 1-3 Pg 5 for instructions <br />on how to cut screws) then use spacer A.250. Use <br />a knife and cut off small end of the spacer (Fig. 2a) <br />and use around the screw between the support <br />plate and embedded ring. CAUTION: FAILURE <br />TO USE THE CORRECT SPACERS MAY CAUSE <br />THE POOL COVER SUPPORT PLATE TO BE <br />PULLED FROM THE POOL OR SPA SURFACE. <br />CAUTION: IF THE SPACERS PROVIDED DO <br />NOT PROPERLY FILL THE GAP BECAUSE OF <br />POOL INTERIOR SURFACE LEVEL IN <br />RELATION TO THE SUMP OR EMBEDDED <br />RING STOP. DO NOT USE THE THREADED <br />INSERTS GO TO METHOD DESCRIBED IN 3F <br />PAGE4 TO COMPLETE THE INSTALLATION. <br />For technical assistance call 1.800.621.5886 or contact your regional representative <br />3