WORK PLANS - Laserfiche WebLink

Home Browse Search

4. First-aid measures Inhalation Move to fresh air. Call a physician if symptoms develop or persist. Skin contact Remove contaminated clothing.Wash with plenty of soap and water. If skin irritation occurs: Get medical advicelattention. Wash contaminated clothing before reuse. Eye contact Immediately flush eyes with plenty of water for at least 15 minutes. Remove contact lenses, if present and easy to do.Continue rinsing. Get medical attention immediately. Ingestion Rinse mouth. Never give anything by mouth to a victim who is unconscious or is having convulsions. Do not induce vomiting without advice from poison control center. Get medical attention if symptoms occur. Most important Severe eye irritation. Symptoms may include stinging,tearing, redness,swelling, and blurred symptomsteffects,acute and vision. Permanent eye damage including blindness could result. Skin irritation. May cause redness delayed and pain. Indication of immediate Provide general supportive measures and treat symptomatically. Keep victim under observation. medical attention and special Symptoms may be delayed. treatment needed General information Ensure that medical personnel are aware of the material(s)involved,and take precautions to protect themselves. 5. Fire4ighting measures Suitable extinguishing media Water spray. Carbon dioxide(CO2). Dry chemical powder. Foam. Unsuitable extinguishing Do not use water jet as an extinguisher,as this will spread the fire media Specific hazards arising from During fire, gases hazardous to health may be formed. Combustion products may include: carbon the chemical oxides, phosphorus compounds and metal oxides. Special protective equipment Self-contained breathing apparatus and full protective clothing must be worn in case of fire. and precautions for firefighters Fire fighting Move containers from fire area if you can do so without risk. Water spray should be used to coal equipment/instructions containers. Specific methods Use standard firefighting procedures and consider the hazards of other involved materials. General fire hazards No unusual fire or explosion hazards noted. 6. Accidental release measures Personal precautions, Keep unnecessary personnel away. Keep people away from and upwind of spill/leak. Surfaces protective equipment and may become slippery after spillage. Wear appropriate protective equipment and clothing during emergency procedures clean-up. Do not touch damaged containers or spilled material unless wearing appropriate protective clothing. Ensure adequate ventilation. Local authorities should be advised if significant spillages cannot be contained. For personal protection,see section 8 of the SDS. Methods and materials for Spilled product may create a slipping hazard.The product is immiscible with water and will spread containment and cleaning up on the water surface. Large Spills: Stop the flow of material, if this is without risk. Use water spray to reduce vapors or divert vapor cloud drift. Dike the spilled material,where this is possible. Cover with plastic sheet to prevent spreading.Absorb in vermiculite, dry sand or earth and place into containers. Following product recovery,flush area with water. Flush area clean with lots of water. Be aware of potential for surfaces to become slippery. Small Spills:Wipe up with absorbent material (e.g. cloth, fleece). Clean surface thoroughly to remove residual contamination. Never return spills to original containers for re-use. For waste disposal,see section 13 of the SDS. Environmental precautions Avoid discharge into drains,watercourses or onto the ground. 7. Handling and storage Precautions for safe handling Do not get this material in contact with eyes.Avoid contact with eyes, skin,and clothing. Provide adequate ventilation. Wear appropriate personal protective equipment. Observe good industrial hygiene practices. Conditions for safe storage, Store in original tightly closed container. Store in a cool,dry,well-ventilated place. Store away from including any incompatibilities incompatible materials(see Section 10 of the SDS). Recommended storage containers: plastic lined steel, plastic, glass,aluminum,stainless steel,or reinforced fiberglass. 3-D Microemulsion@ SDS US 923937 Version#:01 Revision date:- Issue date:22-April-2015 2/6