Laserfiche WebLink
Troubleshooting for Feeder <br /> Problem:Excessive Motor Load <br /> Possible Solution: <br /> 1. Usually caused by a plugged condition in the inlet of the separator or tail section of the <br /> conveyor <br /> Problem:Bent Paddles <br /> Possible Solutions: <br /> 1. May be caused by plugged condition at discharge. Material is not being taken away from the <br /> conveyor. <br /> 2.A piece of foreign material may have dropped into the conveyor and caused paddles to bend. <br /> Problem:Gear Reducer Excessively Noisy <br /> Possible Solutions: <br /> 1.Oil level not properly maintained.All gear boxes are shipped without oil.Gear reducers should <br /> be filled at the time of installation in accordance with the manufacturer's recommendations. <br /> 2. Drain and refill oil in the Gear reducer seasonally. <br /> Chain misalignment or improper chain tension can transmit vibration through Gear Reducer. <br /> Suggested Settings For Various Materials <br /> See Applications Guide for more information <br /> Required Tools &Supplies: <br /> T20&T30 only: -- ,.-�-:- �• <br /> T20-2"X 32"L combination wrenches(for tightening and loosening paddles) <br /> T30-2 W X 32"L combination wrenches (for tightening and loosening paddles) <br /> T20,T30,T42,THOR/Mega THOR <br /> 1 <br /> 20 ; e <br />