Laserfiche WebLink
3/15/24,2:54 PM S Bravo Problem Solved <br /> Home Products pe-sourcesAbout: Contact Us <br /> EP100: used for New Construction fitting application <br /> EP100RF: used for Retrofit fitting application <br /> PE250: used when chemically bonding to Polyethylene, Poly wall or secondary wall <br /> of Flexible piping <br /> PS400 <br /> NY260: used to bond to OmegaFlex piping or APT XP outer jacket which are a <br /> nylon material <br /> Cure Cycle: the Full Cure Cycle can be tested in a simple manner of using the tip <br /> of a knife to do a scratch test on the Slurry/ EP100/ EP100RF/Lamination. First, use <br /> your fingernail to see if the material can be dented. If it does not dent, then <br /> perform the scratch test. <br /> Adhesive Kits: S Bravo Adhesive kits are sent with the proper ratio of Part A and <br /> Part B. Use the kits in a one to one ratio. Do not attempt to divide the kit as this <br /> may hinder or deter the bonding process. <br /> Bravo Epoxy and Slurry: the Hardener portion of these Adhesive kit must to be <br /> shaken thoroughly to agitate and mix the colorant within the hardener. The <br /> Hardener should be a bright yellow color. if it is not, look to see if the colorant is <br /> sticking to the bottom of the hardener container. If so, gently stir it together <br /> carefully, then secure the lid tightly and shake again. <br /> Hardener for Epoxy and Slurry: colorant (Yellow) has been added to the hardener <br /> for these kits to aid in the mixing process. The yellow hardener makes it easier to <br /> know when the mixing process is complete. The color should be a consistent <br /> yellow and consistent texture. Look for white chunks or pieces in jar along the <br /> edge of the jar and then continue to mix until color is consistent. <br /> I <br /> BAiO NAVIGATION LOCATIONS CONTACT <br /> emc�: WEST COAST (323) 888-4133 <br /> hftps://www.sbravo.com/fags 5/6 <br />