SU-2601231_SSNL - Laserfiche WebLink

Home Browse Search

test holes. Percolation test procedures conformed to San Joaquin County Environmental Health Department policy. Preparation and Presaturation of Percolation Test Holes After the borings were advanced by hand auger and the soil logged, the test holes were completed for the percolation testing. Approximately two inches of pea gravel were placed in the bottom of each open soil boring, followed by a 2.0-inch diameter PVC pipe with perforations on the bottom. Pea gravel was then used to backfill a few inches of the annular space. Live Oak presaturated the percolation test holes approximately 24 hours prior to the percolation testing. Each hole was filled with water to a height of 12 inches above the bottom of the boring for the presaturation. On the day of testing, both holes were found to be intact and dry. Percolation Test Procedure Live Oak conducted the percolation test for the borings on February 26, 2026. Percolation test procedures conformed to San Joaquin County Environmental Health Department policy. Due to initial percolation rates observed, a standard four-hour test was selected for the shallow boring, and a one-hour test was selected for the deep boring. Water level measurements were taken every 30 minutes during the four-hour period and every ten minutes during the one-hour period. Rena LeRoy, Environmental Health Specialist at the San Joaquin County Environmental Health Department, observed the final 30 minutes of the percolation testing. An electronic well sounder with a depth accuracy of 1/100th foot was utilized for the water level measurements. The water level was measured against a fixed reference point on the well casing. Measurements were recorded on the data sheet in decimal feet. When necessary after measuring the water level, each hole was refilled with water to a level of approximately six inches above the bottom of the hole. Percolation Test Results The completed percolation test form is included in Appendix 3 of this report. The form was signed by Ms. LeRoy and indicates a percolation rate for each hole based on the final water drop observed. Per San Joaquin County Environmental Health Department's definition, a shallow percolation test hole has a depth between 18 and 42 inches; a satisfactory percolation rate for a shallow test is greater than or equal to 1 minute per inch (min/in) but less than or equal to 60 min/in drop. A deep percolation test hole has a depth between 3.5 and 25 feet; a satisfactory percolation rate for a deep test is greater than or equal to 1 min/in LOGE 2611 Page 6