Laserfiche WebLink
ARB Approved IOM — HealyNeedei-Root Phase II EVR System — VR -202-A (CAS — 9961) Page 20 <br />INSTALLATION INSTRUCTIONS for <br />HEALY SYSTEMS, INC. <br />CLEAN AIR SEPARATOR <br />The Model 9942, Healy Systems Clean Air Separator Installation consists of a 400 gallon steel tank <br />assembly (9961) that contains a fuel resistant bladder to contain excess gasoline vapors that may <br />develop in gasoline storage tanks during idle periods of gasoline dispensing facility operation. The <br />tank assembly weighs approximately 800 pounds which makes it necessary to have a power <br />assisted lifting device available at the installation site to remove the tank from the transportation <br />vehicle and place it on the required concrete pad (see drawing B9900-9945). The pad (level within <br />1/8"/foot) is located within 100 feet to the storage tank vent lines. The pad is a requirement of this <br />installation. DO NOT PLACE THE TANK DIRECTLY ON THE GROUND OR ASPHALT SURFACE. <br />NOTICE: The installer is responsible to ensure that the installation meets the latest edition <br />requirements of NFPA 30A, Chapter 10. No electrical connections are required. The tank <br />securement method shown in drawing B9900-9945 shall be approved by the local authority having <br />jurisdiction with respect to wind and seismic loading. <br />In addition to the tank, there is a hardware kit that contains the following: <br />1 PressureNacuum vent valve (See Exhibit 1 of VR -202-A for model number) <br />4 Locking 1" NPT Ball Valves <br />4 Pad locks (keyed alike) <br />1 Breather Assembly, Healy Model 9948 <br />1 Vapor Inlet Assembly, Healy Model 9956 <br />1 Float Check Valve Assembly, Model 9466G <br />Reference the appropriate Healy Systems installation drawing (C9900-9942, C9900-9971, C9900- <br />9972 or C9900-9973 of this manual) for placement of the above parts for the vent stack <br />configuration required by the local Authority Having Jurisdiction (AHJ) for the UST system. The <br />local contractor is responsible to provide all necessary, galvanized piping, non -hardening, UL <br />classified pipe joint compound and plumbing fittings. Additional PressureNacuum (P/V) vent valves <br />to complete installation are not included in the hardware kit. Healy is not responsible for the <br />warranty of any other PN vent valve purchased to complete installation. <br />The tank arrives at the site assembled and tested. All plumbing should be done using 1" galvanized <br />steel pipe (Schedule 40) and approved nipples, as called out in the installation drawing appropriate <br />for the site installation. Mounting hardware should be galvanized or stainless steel. Careful <br />attention must be paid to the installation drawing appropriate for the site installation to assure proper <br />operation of the bladder system. Do not inflate the bladder assembly after installation. <br />It is important that the tank be secured to the concrete pad as shown in drawing B9900-9945 of this <br />manual to prevent any unintentional repositioning of the tank as the connecting plumbing to the vent <br />system is accomplished. <br />Healy Systems, Inc. Website: http://www.healysystems.com <br />18 Hampshire Drive Email: sales@healysystems.com <br />Hudson, New Hampshire 03051 USA Telephone: 603.882.2472 <br />ARB Approved Installation, Operation and Maintenance Manual (August 31, 2005) Fax: 603.882.5189 <br />Healy Systems, Inc. — the innovative leader of Stage 11 vapor recovery equipment <br />