Laserfiche WebLink
D. Results of Testing/Servicing <br />Software Version Installed: 132.00 <br />C:mmnlptp the fnlinwinn rhprklict- <br />x Yes <br />❑ No* <br />Is the audible alarm operational? <br />z Yes <br />❑ No* <br />Is the visual alarm operational? <br />x Yes <br />❑ No* <br />Were all sensors visually inspected, functionally tested, and confirmed operational? <br />z: Yes <br />❑ No* <br />Were all sensors installed at lowest point of secondary containment and positioned so that other equipment will not interfere with their <br />roper operation? <br />Yes <br />a No* <br />If alarms are relayed to a remote monitoring station, is all communications equipment (e.g. modem) operational? <br />KI N/A <br />x Yes <br />❑ No* <br />For pressurized piping systems, does the turbine automatically shut down if the piping secondary containment monitoring system <br />❑ WA <br />detects a leak, fails to operate, or is electrically disconnected? If yes: which sensors initiate positive shut -down? (Check all that apply) <br />IE7Sump/Trench Sensors; E]Dispenser Containment Sensors. Did you confirm positive shut -down due to leaks and sensor <br />failure/disconnection? ®Yes; ONo. <br />x Yes <br />n No* <br />For tank systems that utilize the monitoring system as the primary tank overfill warning device (i.e. no mechanical overfill prevention <br />[I NIA <br />valve is installed), is the overfill warning alarm visible and audible at the tank fill point(s) and operating properly? If so, at what percent <br />of tank capacity does the alarm trigger? so <br />x Yes* <br />❑ No <br />Was any monitoring equipment replaced? If yes, identify specific sensors, probes, or other equipment replaced and list the <br />manufacturer name and model for all replacement parts in Section E, below. <br />Yes* <br />9-1 No <br />Was liquid found inside any secondary containment systems designed as dry systems? (Check all that apply) []Product; []Water. If <br />es, describe causes in Section E, below. <br />io Yes <br />ii No* <br />Was monitoring system set-up reviewed to ensure proper settings? Attach set up reports, if applicable <br />Yes <br />❑ No* <br />Is all monitoring equipment operational per manufacturer's specifications? <br />* In Section E below, describe how and when these deficiencies were or will be corrected. <br />E. Comments: <br />Replaced like for like 794380-208 sensor in udc 20M Retested and all ok. Unable to test <br />vositve shutdown on T-1 Feedinq the auto side due to turbin been out of service. <br />Monitoring System Certification Page of 12/07 <br />