COMPLIANCE INFO - Laserfiche WebLink

Home Browse Search

04/02/2001 Du Pont Page 9 of 12 Material Safety Data Sheet - 12395S - CHROMAPREMIER Inhalation: If affected by inhalation of vapor or spray mist, move to fresh air. If not breathing, give artificial respiration, preferably mouth-to-mouth. If breathing difficulty persists, or occurs later, consult a physician. Ingestion: In the unlikely event of ingestion, DO NOT INDUCE VOMITING. Call a physician immediately and have names of ingredients available. Skin or eye: In case of contact, immediately flush with plenty of water for at least 15 minutes; call a physician. In case of skin contact, wash thoroughly with soap and water. If irritation occurs, contact a physician. ****** SECTION 5 - Firefighting Measures ****** Flash Point (Closed Cup) See Section 11 for exact values. Flammable limits LFL 0.8 % UFL 13.1 % Extinguishing media: Universal aqueous film-forming foam, carbon dioxide, dry chemical . Fire fighting procedures: Full protective equipment, including self-contained breathing apparatus, is recommended. Water from fog nozzles may be used to prevent pressure build-up. Fire & explosion hazards: For flammable liquids, vapor/air will ignite when an ignition source is present. In other cases, when heated above the flash point, emits flammable vapors which, when mixed with air, can burn or be explosive. Fine mists or sprays may be flammable at temperatures below the flash point. ****** SECTION 6 - Accidental Release Measures ****** Steps to be taken in case material is released or spilled: Ventilate area. Remove sources of ignition. Prevent skin and eye contact and breathing of vapor. If the material contains, or is mixed with an isocyanate activator/hardener: Wear a positive-pressure, supplied-air respirator (NIOSH approved TC-190 , eye protection, gloves and protective clothing. Pour liquid decontamination solution over the spill and allow to sit at least 10 minutes. Typical decontamination solutions for isocyanate containing materials are: 20% Surfactant (Tergitol TMN 10) and 80% Water OR 0 -10% Ammonia, 2-5% Detergent and Water (balance) Pressure can be generated. Do not seal waste containers for 48 hours to allow CO2 to vent. After 48 hours, material may be sealed and disposed of properly. If material does not contain or is not mixed with an isocyanate activator/hardener: Wear a properly fitted air-purifying respirator with organic vapor cartridges (NIOSH approved TC-230 , eye protection, gloves and protective clothing. Confine, remove with inert absorbent, and dispose of properly.