Laserfiche WebLink
"04/02/2001 Dii pont Page 2 of 5 <br /> Product Usage Data Sheet - 7160S <br /> Note: Be sure to activate the ready-to-spray basecoat at the normal 1 ounce of <br /> Activator per ready-to-spray quart of color before application. <br /> Viscosity <br /> 15 - 17 seconds in a Zahn #2 (DuPont M-222) cup. <br /> Tips for Success <br /> Use mixing stick for accurate measurements. <br /> ■ Use activated basecoat within 2 hours for optimum performance. <br /> ■ Do not use activated basecoat after the 8-hour pot life. <br /> ■ Activate only what you intend to spray. <br /> Pot Life <br /> 8 hours. <br /> Additives <br /> Accelerator: Not recommended. <br /> Fish Eye Eliminator: Not recommended. <br /> Flex Additive: Not recommended: see Tips for Success. <br /> Retarder: Not recommended. <br /> Tips for Success <br /> ■ If fish eyes occur, allow the basecoat to dry thoroughly, then apply dry <br /> coats of base color to bridge the affected area. <br /> ■ The use of Activator 12305S in ChromaPremierTM Basecoat is mandatory. The <br /> recommended 1 ounce of 12305S per ready-to-spray quart of basecoat gives <br /> optimum performance over flexible substrates. No other flex additive is <br /> necessary. <br /> ■ Do not add Accelerator to activated basecoat. It will not speed cure and <br /> could damage film properties. <br /> Tinting <br /> Up to 5% with MasterTint mixing color. <br /> Clearcoats <br /> ChromaPremierTM Appearance Clear 72400S <br /> ChromaPremierTM Productive Clear 72200S <br /> ChromaClear 7500S / 7600S / 7800S / V-7500S / V-7600S <br /> Flatteners <br /> Flattening agents are not recommended to flatten ChromaPremierTM Basecoat. <br /> Small amounts of Flattener 4530S may be used to adjust color for flake <br /> orientation in metallic and pearl colors. <br /> Application <br /> Substrates <br /> Adhesion Promoter 222S <br /> Plas-StickTM Flexible Adhesion Sealer 23405 <br />