Laserfiche WebLink
'04/02/2001 Du Pont Page 4 of 5 <br /> Product Usage Data Sheet - 7160S <br /> Blending <br /> Apply 1 coat of Adhesion Promoter 222S, over the entire repair area. Apply the <br /> first coat of color beyond the primed area. Apply the second coat just beyond <br /> the first coat. Apply subsequent coats just beyond the previous coats, staying <br /> within the area covered by 222S. Follow recommended flash times, then apply <br /> clearcoat over the entire panel . <br /> Tips for Success <br /> ■ Tapering out each consecutive coat melts the new color into the old color. <br /> ■ Use of a slower Basemaker(R) can improve the appearance of the blend edge. <br /> ■ For advanced blending techniques, see Special Blending Procedures in the <br /> Specialty Procedures section. <br /> Recoatability/Re-repair <br /> ChromaPremierTM Basecoat may be recoated with itself at any time within 24 <br /> hours. <br /> Sanding <br /> ChromaPremierTM Basecoat dries to a smooth matte finish and should not require <br /> sanding. Nib sanding of small areas to remove dirt must be followed by the <br /> application of more color before clearcoating. <br /> Cleanup <br /> Clean spray equipment as soon as possible with DuPont Lacquer Thinner. <br /> Physical Properties <br /> VOC: 6.2 lbs/gal ready-to-spray (maximum) . <br /> Theoretical Coverage: 150 sq.ft. (silver) and 192 sq.ft. (white) per RTS gal . <br /> at 1 mil . <br /> Weight Solids: 14.0% (silver) and 23.1% (white) ready-to-spray using 71605. <br /> Volume Solids: 9.4% (silver and 12.0% (white) ready-to-spray using 71605. <br /> Recommended Dry film Thickness: 0.5 - 2.0 mils. <br /> Flash Point: See MSDS. <br /> VOC Regulated Areas <br /> These directions refer to the use of products which may be restricted or <br /> require special mixing instructions in VOC regulated areas. Follow mixing and <br /> usage recommendations in the VOC Compliant Products Chart for your area. <br /> Safety and Handling <br /> Before using any DuPont product, be sure to read all safety directions and <br /> warnings. WEAR A POSITIVE-PRESSURE, SUPPLIED AIR RESPIRATOR (NIOSH TC-190 , <br /> EYE PROTECTION, GLOVES AND PROTECTIVE CLOTHING WHILE MIXING ACTIVATOR WITH <br /> PAINT, DURING APPLICATION AND UNTIL ALL VAPORS AND SPRAY MISTS ARE EXHAUSTED. <br /> Follow respirator manufacturer's directions for respirator use. INDIVIDUALS <br />